APRILIA RSV4 POWER SHIFT NRG-RSV4 installation manual

0

Filed Under (Aprilia) by admin on 26-10-2010

download
WIRING INSTALLATION 1. Unfold the Power Shift wiring, as it is shown by the figure to place the main connector in the area where to secure the IS-MODULE, the black wire eyelet in the proximity of the battery negative pole and the 12V red power supply wire around the battery to reach the connector of the rear brake switch, as it is specified by the figure. The connectors with the label relative to every single cylinder shall be positioned as it is shown 2. Connect the Power Shift connectors with those of the corresponding coils by following the label on the supplied cable and the position of every single cylinder, just as it is specified by the following images Connect the red power supply wire with the connector of the rear brake switch, as it is specified by the figure, and the ground ring with the negative battery pole

Write a comment