ARLEY DAVIDSON FXDL INSTRUMENT CONSOLE INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 28-03-2011

download
Installation CONSOLE REMOVAL To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables (negative cable first) before proceeding. Disconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury (00049a). 1. Remove seat and disconnect battery, negative cable first. 2. Remove fuel tank mounting bolts. Lift fuel tank far enough to remove the speedometer sensor cable from the mounting clips under the tank. 3. See Figure 1. The 3-place speedometer sensor connector is located on the frame beneath the seat. Remove from t-stud and disconnect the connector. Cut the cable strap that holds sensor wires to right rear frame tube. 4. Remove instrument console mounting screws and lift console from tank. SPEEDOMETER REMOVAL 1. See Figure 2. Disconnect 8-place connector under console. Remove assembly from tank. 2. Cut remaining cable straps holding wires to instrument mounting bracket. Remove screws holding bracket to back of instruments. Remove bracket. 3. See Figure 3. Remove nuts and washers from terminal studs (1, 2 and 3). Remove wires from studs. 4. Unscrew the rubber function switch cover that protrudes from the left side of the console. Remove the function switch (3). 5. Gently push on bottom of speedometer and remove speedometer from top side of console. Remove gasket from speedometer. TACHOMETER REMOVAL 1. See Figure 3. Remove nuts and washers from terminal studs (3, 4 and 5). Remove wires from studs. 1 WARNING 1 WARNING

Comments are closed.