HARLEY DAVIDSON CHROME DUAL GAUGE KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 18-04-2011

download
Installation To protect against shock and accidental start-up of vehicle, disconnect the negative battery cable before proceeding. Inadequate safety precautions could result in death or serious injury. Always disconnect the negative battery cable first. If the positive battery cable should contact ground with the negative cable installed, the resulting sparks may cause a battery explosion which could result in death or serious personal injury. Removal DISCONNECT ELECTRONIC SPEEDOMETER AND TACHOMETER 1. Refer to applicable Service Manual procedure and remove seat. 2. Refer to XLH Service Manual procedure and remove fuel tank. On FXD models, remove fuel tank mounting bolts and lift tank. 3. See Figures 1 and 2. The 3-place speedometer sensor connector [65] is located on the frame beneath the seat. Remove connector from t-stud and disconnect. Detach sensor harness from left frame tube. 1 WARNING 1 WARNING 1 WARNING 4. Detach headlamp assembly from top fork bracket, to allow removal of speedometer sensor harness. 5. Unscrew speedometer reset switch boot. Remove cover screws and covers from backs of gauges. NOTE Some early electronic speedometers and tachometers were wired directly into the gauge

Comments are closed.