HARLEY DAVIDSON DYNA ACCESSORY SEAT KITS INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 29-01-2011

download
For vehicles with 2-up seating 1. Remove the existing seat from motorcycle. Save the mounting screw for installation of the new seat. 2. Remove existing grab strap and all attaching hardware. 3. See Figure 1 for information on which holes to install grab strap through for your seat (use the hole shown dark in the illustration). Install new grab strap onto motorcycle at same location old grab strap was removed (re-use existing hardware). Tighten to 60-90 in-lbs (6.78-10.17 Nm) . 4. Position new seat on motorcycle. Be sure tongue on front of seat fully engages into the seat mounting slot between the gas tank bracket and frame. 5. Secure seat with stock screw. After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) Kit Number: 52284-06 and 52359-06 Kit Number: 52159-06 Kit Number: 51540-06 Kit Number: 52288-06 Kit Number: 51471-06 and 51472-06 Grab StrapNumber: 52370-04 Grab StrapNumber: 51176-96B Grab StrapNumber: 51173-93 Grab StrapNumber: 51176-96B Grab StrapNumber: 51173-93 Kit Number52378-07 Grab StrapNumber: 52313-96 is03552a Figure 1. Grab Strap installment information For vehicles with solo seat 1. Remove the existing seat from the motorcycle. Save the mounting screw for installation of the new seat. 2. See Figure 2. Remove the plastic cap from the rear most fender hole (3). 3. Remove the seat retention nut and washer from the solo seat mounting hole

Comments are closed.