HARLEY DAVIDSON ENRICHENER KNOB COVER INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 28-02-2011

download
Additional Parts Required Loctite® 222 (purple) Installation NOTE If there are any rough edges around enrichener knob that prevent enrichener knob cover from sliding in place, remove them using fine grit sandpaper or emery cloth. 1. See Figure 1. Install collet (4) to the enrichener knob (A), the enrichener knob cover (2) and gasket (3) as shown. Apply Loctite 222 (purple) to threads of screw (1). Line up hole in collet with hole in enrichener cover and insert screw. Tighten screw. 1 2 3 A 4 is03857 1. Screw 2. Enrichener Knob Cover 3. Gasket 4. Collet Figure 1. Enrichener Knob Cover Installation

Comments are closed.