HARLEY DAVIDSON FXDWG ENGINE GUARD KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 11-03-2011

download
FXDWG ENGINE GUARD KIT General This kit is designed for installation on 1993 and later FXDWG Dyna Wide Glide. QTY DESCRIPTION 1 Engine guard 2 U-Bolt 4 Locknut 1 Bolt, 3/8-16 x 7/8 in. 1 Lockwasher, 3/8 in. 1 WARNING This engine guard may provide limited leg and cosmetic vehicle protection under unique circumstances (fall over while stopped, very low speed slide). However, it is neither designed nor intended to provide protection from bodily injury in a collision with a vehicle or any other object. Installation 1. Lift engine guard into place. Align top center mount of guard with frame crosspiece member between frame downtubes. 2. Secure top center mount to frame crosspiece member using 3/8-16 x 7/8 in. bolt and lockwasher included in kit. Do not fully tighten at this time. 3. On right side of motorcycle, install U-bolt from kit around the frame member and into the holes in the lower mounting bracket. Secure loosely into place using two locknuts from kit. 1 CAUTION Left U-bolt must be installed between the frame and the clutch cable. Do not pinch clutch cable between the U- bolt and the frame. 4. On left side of motorcycle, install remaining U-bolt from kit around the left frame member and into holes in lower mounting bracket. Secure loosely into place using two locknuts from kit. 5. Tighten upper mounting bolt installed in step 2, to 30-33 ft-lbs. Alternately tighten U-bolt hardware to 25 ft-lbs. Tighten left and right side U-bolts evenly, so that approximately the same length of bolt protrudes from end of nut

Comments are closed.