HARLEY DAVIDSON LED TAIL LAMP WITH BAR AND SHIELD LOGO INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 10-02-2011

download
INSTALLATION For models WITH maxi-fuse: To prevent accidental vehicle start-up, which could cause death or serious injury, remove maxi-fuse before proceeding. (00251a) 1. Refer to the Owner’s Manual and follow the instructions given to remove the seat and maxi-fuse. Retain all seat mounting hardware. For models WITHOUT maxi-fuse: To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) NOTE For 2004 and later XL (Sportster┬«) models, the negative battery cable is most easily disconnected at the engine crankcase . 1. Refer to the Owner’s Manual and follow the instructions given to remove the seat and disconnect the negative (black) battery cable from the negative (-) battery terminal. Retain all seat mounting hardware. NOTE Figure 1 shows the original equipment tail/stop lamp mounted to a full fender. The lamp is rotated 180┬░ when mounted to a Bobtail fender. 2. See Figure 1. Loosen the two Phillips head screws (2) retaining the tail/stop lamp assembly (1) to the lamp base (3), and pull the lamp assembly away from the base. 3. Depress the locking tab (button), and disconnect the tail/stop lamp four-way Multilock socket housing [93B] (4) from the circuit board. Remove the lamp from the vehicle. 3 1 4 2 is02969 1. Tail/stop lamp assembly 2. Tail/stop lamp retaining screw (2) 3. Tail/stop lamp base 4. Tail/stop lamp connector [93B] Figure 1. Removing the Tail/Stop Lamp Assembly 7 6 2 5 1 3 4 is02970 1. Socket housing 2. Secondary lock 3. Locking tab (button) 4. Cavity 5. Socket terminal 6. Slot 7. Crimp tails Figure 2. Socket Terminal Installation 4. On the new tail/stop lamp assembly, the Blue wire and socket terminal are not installed in the four-way socket housing. Refer to the original lamp removed in Step 3, and observe which cavity contains the Blue wire. Note that the cavities are numbered on the face of the secondary lock. The Blue wire and terminal must be

Comments are closed.