HARLEY DAVIDSON POWER LOCK KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 17-04-2011

download
INSTALLATION To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Disconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00049a) 1. Disconnect the battery, negative (-) battery cable first, following the instructions in the appropriate Service Manual. 2. Remove seat following the instructions in the appropriate Service Manual. Preparing the Saddlebags for Power Locks 1. Remove saddlebags following the instructions in the appropriate Service Manual. 2. See Figure 1. Remove lid (1) and hinge (2) from sad- dlebag. 3. Remove lock (3) from saddlebag. 4. See Figure 2. Set drill template on hinge surface of the saddlebag aligning the template (5) with hinge mounting holes (7). 5. See Figure 3. Drill 0.344 (11/32) inch diameter hole (1). 6. Place the template on the back of the saddlebag (4) aligning front mounting grommet (2) and forward latch bracket (1). 7. See Figure 4. Drill 0.500-0.515 inch diameter hole (1). 8. Repeat on the other saddlebag. 1 2 3 is04988 1. Saddlebag lid 2. Saddlebag hinge 3. Saddlebag lock Figure 1. Remove Lid, Hinge and Lock from Saddlebag

Comments are closed.