HARLEY DAVIDSON SCREAMIN' EAGLE MECHANICAL COMPRESSION RELEASE FIX- TURE

0

Filed Under (Harley Davidson) by admin on 04-02-2011

download
DRILLING AND TAPPING PROCEDURE Wear safety glasses or goggles while drilling. Flying debris could result in serious eye injury. (00565b) NOTE Perform the following procedure on both the front and rear cylinder heads. Tool Setup NOTE Due to slight manufacturing differences, it may be necessary to tap the fixture into place with a rubber mallet. Do NOT use excessive force. 1. Align the fixture’s locating pins with the 3/8 inch tooling holes in the head and install the fixture on the head. 2. See Figure 1 and Figure 6. Secure the fixture (1) to the head with two 5/16-18 socket head cap screws (2) and washers (9) included in the kit. Install the screws in the holes marked “F” when modifying the front head or in the holes marked “R” when modifying the rear head. Tighten screws to 80 in-lbs (9 Nm) . 3. See Figure 3 and Figure 6. Install the drill bushing (3) in the bore marked “FRONT” when modifying the front head or in the bore marked “REAR” when modifying the rear head. 4. Tighten drill bushing set screw to 50 in-lbs (5.6 Nm) . 5. See Figure 2 and Figure 6. Install collar stop (4) onto the 1/2 inch diameter shank of the step drill bit (5). Secure the collar stop with the set screw 3.900 inches (9.90 cm) from the beginning of the 3/4 inch diameter step of the drill bi

Incoming search terms:

Comments are closed.

Incoming search terms: