HARLEY DAVIDSON SHORT CB ANTENNA MAST REMOVAL AND INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 08-03-2011

download
Additional Parts Required 1998 through 2008 models require use of the original equipment (OE) load coil. 2009 and later models DO NOT require use of a load coil. Kit Contents There are no service parts available with this kit. INSTALLATION 1. 2008 and earlier models: Use a 2 mm hex key to loosen the bottom set screw of the antenna mast. ALL models: Unscrew the antenna mast from the antenna base. 2. Thread the new antenna mast onto the threads of the antenna base. IN SERVICE 2008 and earlier models: If a degradation of CB performance is detected: 1. Open the Tour-Pak. 2. Open the map pocket (if present), and remove the acorn nuts with flat washers. Remove the map pocket and molded liner from the Tour-Pak. 3. Check the routing of the load coil wiring (see Figure 2). Wire routing other than as shown can cause a degradation of the CB signal

Comments are closed.