HARLEY DAVIDSON ULTRA TOUR-PAK BRAKE LAMP CHROME ACCENT COVERS INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 24-02-2011

download
Installation- Corner Brake Lamp Trim 1. Carefully cut out brake lamp trim template (1) attached to this instruction sheet. 2. Position template (1) on plastic brake housing (2) as shown in Figure 2. 3. Using a punch, score two points indicated on template to mark mounting hole locations (3) on plastic brake housing (2). 4. Using a 1/8 in. drill bit, drill a pilot hole in plastic housing. 5. Use a 7/32 in. drill bit to drill through housing and fiberglass Tour-Pak. 6. See Figure 3. Insert studs on chrome brake lamp trim piece through holes drilled in plastic housing and Tour- Pak. Using two flatwashers (1), two lockwashers (2) and two acorn nuts (3) from kit, secure trim piece to Tour- Pak. Tighten finger tight. 7. See Figure 3. Locate brake lamp retaining clip (4) on inside of Tour-Pak and remove. Save clip (4) for later reinstallation. 8. Form chrome trim around corner of Tour-Pak, so that it is positioned around plastic housing evenly. While holding chrome trim in position, mark forward mounting hole position on Tour-Pak using a punch

Comments are closed.