1997-2003 HONDA CBR1100 XX Black Bird Complete Brake Line Kit INSTALLATION

0

Filed Under (Honda) by admin on 05-11-2011

download
identify the key components that complete our brake line kit: You should have eleven (11) hoses, one (1) double banjo bolt, fourteen (14) single banjo bolts, (1) Installation CD. There are also a total of Thirty Six (36) washers and two (2) “olive” conic inversors two (2) c-clips. Thirty Two (32) washers will be used, and two olives. The rest are spares. Step 2: Familiarize yourself with the brake lines, which are labeled for application. Lettered brake hoses A, B, C, D, E, F, G, H, K, I are installed on the front of the motorcycle, while brake hoses (J and K) are installed on the rear. Each label will reference a different drawing, which will show you the location of each brake line. Step 3: To ensure no paint damage from brake fluid, completely cover the bike. This process can be messy, and brake fluid WILL drip! Step 3: Dry out (bleed) your OEM hoses, and take note of how the stock system is installed. You may want to take a
couple pictures, in case you need to re-install. Step 4: Remove the stock hoses on the front of the motorcycle, and replace with Galfer hoses labeled A,B,C,D,E,F,G,H,K,I. Locate lline A. this hose will run from the master cylinder down to the Galfer t-block
joining line B to the right caliper upper mounting point. Line C will travel across the fender down to the left caliper upper mounting point. Line D will run from the (DELAY VALVE) up through the C-CLIP to the right side upper frame O.E.M tubing. The female fitting will thread onto the male with a (OLIVE). This O.E.M tubing travels to the rear master cylinder. Line E Travels from the lower delay valve down to the right caliper lower mounting point. Line F will run from the (SECONDARY MASTER CYLINDER) up through the C-CLIP to the left upper frame O.E.M tubing. The female fitting will thread onto the male with a (OLIVE).This tubing travels tothe rear delay vale

Write a comment