Kawasaki ZX6R 2009 Frame Slider Installation and removal Instructions

0

Filed Under (Kawasaki) by admin on 08-05-2012

download
1. Remove mid and lower body panels Left and Right. There is a small plastic cover that is mounted over the main engine stud location on the left side. This cover requires a small notch to be cut out of the cover to clear the small end of the left side offset. Remove stock stud and mount the left side offset (with 10 X 1.25 X 60). Using a pencil, trace out the notch that you need to remove to clear the small end of the offset. We used a Dremel tool with a sanding roll and cleaned it up with an exacto knife. We removed a small amount of material at a time checking for clearance each time. The notch will not be visible after the body has been mounted. See photos below: 2. Once you have notched the small left side panel, mount the left side offset but only hand tight. You need to be able to move the offset by hand to its proper location. 3. Mount the left side bodywork and align the offset to the opening in the body. Mount the left side slider on the offset to ensure correct location. There is a flat notch in the slider so the body will clear. Remove the slider and body and torque down the offset to OEM specifications. (see above)
4. Mount the left side panel. Install the slider using one drop of blue thread locker and torque down to 30 to 32 ft lbs.

Incoming search terms:

Write a comment

Incoming search terms: