KTM EXC / MXC DUAL SPORT KIT REMOVAL AND INSTALLATION

0

Filed Under (KTM) by admin on 25-01-2012

download
Using a small phillips head screwdriver, loosen the locking screw ( B ) on the kill switch ( C ). Remove any cable ties and unplug kill switch from existing wiring. Step 2 Loosen clutch cable perch ( D ) and move inboard about 1/2 inch. Important Note Regarding Magura Brakes The KTM uses the Magura hydraulic brake, which may cause potential interference between the turn switch and the lever adjuster. Make sure you have enough clearance between the parts. You can either move the grip out slightly, or take a file and sand away a small notch in the turn switch where it may rub. Install Turn Switch Step 1 Open and wrap the new turn switch ( E ) around handlebar and securely fasten with two screws ( F ) as shown. Make sure you have clearance between the grip, the switch and the lever! Step 2 Route turn switch wiring down and along handle bar behind Dakar headlight unit and in through frame cable guide. Secure switch wiring to handlebars with one cable tie. For more information, please refer to the Cable Routing Diagram

Write a comment