Suzuki C-90 VL 1500LC Rear Lowering Kit INSTALLATION AND REMOVAL MANUAL

0

Filed Under (Suzuki) by admin on 20-02-2012

download
1. Decide how far you would like to lower your bike. Refer to the hole-index chart in these instructions to determine the proper mounting location holes for the drop you want to achieve. 2. Secure motorcycle to bike lift and raise the motorcycle so the rear wheel is unweighted. 3. For easiest access to the linkage remove the tool kit holder from the left side of the bike. 4. Loosen and remove the two self-locking nuts and flat washers from connecting arm bolts from the left side of the motorcycle. 5. Slide connecting arm bolts out (it may be necessary to push bushing back to the left side to allow bolt head to drop below frame. Reinstall in the same manner). Replace stock connecting arms with your new Baron connecting arms. The end with the single hole goes down and attaches to relay arm. The end with three holes goes up and attaches to the frame. Use the hole that lowers the rear your chosen amount. Reinstall bolts, washers and nuts. Torque the two connecting arm nuts to 35 foot-pounds (48 Nm). Remove motorcycle from lift. NOTE : We recommend that you set the shock spring preload to a higher setting, especially if the motorcycle will be used for carrying a passenger or heavy loads.

Write a comment