LEXUS RX330 AUDIO SYSTEM HEAD UNIT Service Manual

0

Filed Under (Toyota Manuals) by admin on 02-06-2011

Download
his service manual should be used together with the manual(s) listed below For the parts numbers, adjustments, etc. which are not shown in this manual,refer to the following EXPLODED VIEWS AND PARTS LIST

Cadillac Catera 1997 Steering Column Replacement

0

Filed Under (Uncategorized) by admin on 26-05-2011

Download

NOTICE: The front wheels of the vehicle must be maintained in the straight ahead position and the steering column must be in the LOCK position before disconnecting the steering column or intermediate shaft. Failure to follow these procedures will cause improper alignment of some components during installation and result in damage to the SIR coil assembly. NOTICE: Once the steering column is removed from the vehicle, the column is extremely susceptible to damage. Dropping the column assembly on its end could collapse the steering shaft or loosen the plastic injections that maintain column rigidity. Leaning on the column assembly could cause the jacket to bend or deform. Any of the above damage could impair the columns collapsible design. If it is necessary to remove the steering wheel. Under no condition should the end of the shaft be hammered on, as hammering could loosen the plastic injections which maintain column rigidity. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Disable Supplemental Inflatable Restraint (SIR) system. Remove the steering wheel. Remove the SIR coil. Remove the ignition lock cylinder. Disconnect the theft deterrent immobilizer connector. Remove the immobilizer. Remove the ignition switch. Remove the windshield washer switch.

Incoming search terms:

All 2002 – 2007 Toyota & 2004 – 2007 Scion Models REPAIR MANUAL SUPPLEMENT VEHICLE PULLING TO ONE SIDE

0

Filed Under (Toyota Manuals) by admin on 23-05-2011

Download
Relationship Between Tire Characteristics and Vehicle Pulling to One Side When radial tires are rotating, they have the characteristic of generating force in the lateral direction between the tire and the road surface. This lateral force is comprised of two factors: S Ply-steer, which changes direction according to the rotation direction of the tires.
S Conicity, which is generated in a fixed direction regardless of the tire rotation direction. If these lateral forces are too strong, vehicle pulling will occur. A. Ply-Steer Lateral force due to ply-steer is produced by the construction of the belts inside the tire tread. With radial tires, the wire of the belt is slanted as shown in the illustration below. Thus, it is in the lateral direction that tire tread easily changes shape (stretches), and lateral force is generated between the tire and the road surface in the lateral direction.

Incoming search terms:

Toyota Yaris 2006 up models 5 speed and Automatic Instruction Manual

0

Filed Under (Toyota Manuals) by admin on 23-05-2011

Download
Using the ⑥ bolt (1) and #15 bracket spacer B (1), attach #5 alternator bracket as shown in illustration. Install the alternator upside down. Using the ⑧ head bolt (1) and washer (1), attach alternator to #5 Alternator Bracket.
6. Using ⑱ bolt (1) and ⑬ nut (1), attach the alternator on bottom alternator mount (lowest hole on Bracket A).
7. After installing alternator, make sure the A/C line does not interfere with belts. If it does, push the A/C line forward and make sure the alternator has enough clearance. ⑧Bolt Washer 8. Some models will have addition A/C lines near engine mount (not shown here). Please adjust A/C line to clear alternator pulley. Please find a suitable spot where the A/C line will not interfere with the pulleys and tie theline down with zip ties

Incoming search terms: