BMW Heated Seat Wiring Instructions

0

Filed Under (BMW) by admin on 28-10-2010

download
1. Locate the battery. 2. Find an appropriate and convenient mounting location for the controller. NOTE: The heat controller has adhesive Velcro on the back for mounting on a flat surface. 3. Connect the components per the wiring diagram. Route and secure wires with electrical friction tape and/or wire ties. In this system, the relay control wire is designed to be connected/spliced to a IMPORTANT: “switched”wire such as a tail light, head light, etc. NOTE: For CANbussystembikes (see above), you MUST spliceor connect to anon-board accessory jack circuit. S T EA RELAY BATTERY 10 AMPFUSE HEAT CONTROLLER SPLICE INTO SWITCHED LINE (I.E. TAIL LIGHT OR ACC. JACK HOT LEAD) WIRING DIAGRAM SARGENT CYCLE PRODUCTS Chilliis a registered trademark of Calamander ltd. * BATTERY SIDE OF POWER CONNECTOR INDICATED WITH RED WRAPPING * IMPORTANT! Caution: Sargent’s limited warranty does not extend to any products damaged as a result of accident, misuse, abuse, normal wear and tear, acts of God or other circumstances beyond Sargent’s control, including loss or damage in transit by carrier, or as a result of service or modification by anyone other than Sargent.

BMW R1200 RT World Sport Seat Heated Seat Installation Manual

0

Filed Under (BMW) by admin on 26-10-2010

download
Wire the heated seat(s) and heat controller(s) per the wiring diagram included in the heated seat(s) wiring kit. This wiring diagram is also available on our website at Use the photos below to locate the recommended switched relay wire connection point, and proceed to wire the heated seat(s) and controller(s) per the wiring diagram. IMPORTANT! The BMW R1200 RT motorcycle has a single wire system or CAN (Controller Area Network) bus electrical system. You must connect the heated seat’s switched relay wire to the BMW on-board accessory jack’s hot wire or another switched wire point within the accessory circuit. While there may be many other possible connection points within the accessory circuit, illustrated below is our recommended connection point. NOTE: As an alternative, Special “Y” jack splitters are available for adding additional accessory jacks to a single jack, available from Sargent (#AC-2063) or your local BMW dealer