2007 Honda CBR600RR Power Commander Installation Instructions

0

Filed Under (Honda) by admin on 16-11-2011

download
Remove the bolt that holds the ground wires and bracket for the alternator connectors to the frame on the left hand side of the bike. This allows access to the Throttle Position Sensor connector. Unplug the stock wiring harness from the Throttle Position Sensor (Fig. F).Remove the main seat and the passenger seat. Remove the fuel tank cover. Remove the left hand fairing. Prop the fuel tank up. Lay the PCIII in the tail section temporarily and route the harness underneath the tail sec- tion (Fig. A). Removing the 4 bolts that hold the tail sectionb in place will make this easier Route the harness towards the throttle bodies (Fig. B) Attach the ground wire from the PCIII to the negative side of the battery.

1994 – 1996 Camry L4 A/C COMPRESSOR KNOCKING NOISE REPAIR

0

Filed Under (Toyota Manuals) by admin on 23-10-2011

download
Ensure that the A/C system high & low side refrigerant pressures are normal before Procedure proceeding with the following repair procedure. NOTE: For abnormal system pressures, use the diagnostic procedure given in the Repair Manual to determine the problem. 1. Remove the A/C Compressor. 2. Replace the Alternator Adjusting Bar with the new part number. 3. Replace the Magnetic Clutch Rotor with the new part number. 4. Adjust the clearance between the pressure plate and rotor from 0.35 to 0.60 mm (from 0.014 to 0.024 inch). NOTE: Use shims to adjust the clearance according to Repair Manual. 5. Install the A/C Compressor. 6. Adjust the drive belt tension to 121 ft. lbs. otherwise the condition may persist

Incoming search terms:

TOYOTA TACOMA BODY LIFT KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Toyota Manuals) by admin on 22-09-2011

download
Disconnect both battery cables. Be sure to disconnect the negative cable first, then the positive cable. Remove
the airbag fuse from the fuse box. 4. Remove the wire loom that runs from under the alternator to the battery from the mounting brackets. One bracket is on top of the frame. The other bracket is on the fender well. The plastic mounting-collar will slide off the bracket by pushing on the tab on the collar. 5. Remove the fuse that controls the air bag system from the fuse box (refer to the owners manual for the exact location). 6. Remove the ground wire that runs from the back of the engine to the top of the firewall. Remove the wire loom from the mounting bracket on the firewall. Remove the bracket from the firewall. Turn the bracket upside down. Insert the mounting bolt through the ground wire removed from the firewall, Then through the bracket. Tighten securely. Reinstall the bolt that mounted the ground wire to the firewall. Tighten the bolt securely. Do not attach the wire loom at this time