Dellorto Motorcycle Carburetor Tuning Guide and INSTALLATION

0

Filed Under (Tips and Review) by admin on 04-02-2012

download
Installation angles The tapered-needle-type Carburetor s with concentric, central float chambers have a horizontal main barrel and can be mounted up to a maximum inclination of 40 degrees from the horizontal (figure 3) . For
applications on motocross and trials engines, etc, this inclination should be 30 degrees or less. fig. 3 2.4 Engine connections The Carburetor is usually connected to the engine with one of the following : Male clamp fixing : the male clamp connection used for the flexible fixing of the Carburetor to the engine is usually recommended on motorcycles for motocross, trials, etc or fitted to engines which run to high rpm or those which produce strong vibrations. fig. 4 Female clamp : the female clip connection and the flange connection, with a rigid fitting to the engine, are usable on road motorcycles or fitted to engines which do not generate very strong vibrations

Incoming search terms:

Installation Instructions Highway Mounts for Engine Guards

0

Filed Under (Harley Davidson) by admin on 29-01-2011

download
Loosely assemble the mount and clamp onto the engine guard tube. Without lowers the arm may be mounted on the inside or outside of the crash bar, with lowers it must be mounted on the outside only. Next assemble the bolt, washer, arm & locking pin as shown. Note: You may want the arms to lean outward slightly to give more room for your legs around the fairing lowers. Tighten the front screws securely.(side without the gap) Then the rear. Adjusting the arm angle. Notice that there are 8 locking pin holes in the mount and 7 in the arm. By leaving the pin in the mount and rotating the arm to its next hole will move the arm 50 deg. When you get close to the desired angle you may make adjustments in 5 deg. increments by moving the pin to the next hole in both the mount and the arm. Moving to the next set of holes clockwise will move the arm counter clockwise 5 deg. Moving the pin to the next set of holes counter clockwise will move the arm clockwise 5 deg. This will provide 72 different mounting angles total. Install the large bolt and washer, tighten securely and install your pegs or hi-way boards . Note: When installing boards put the lock or star washer between the board and the arm to prevent them from rotating under heavy pressure.

Incoming search terms: