Harley-Davidson FXWG, FXST (all except FXSTS), FXDWG Light Bar INSTALLATION AND OWNER'S MANUAL

0

Filed Under (Harley Davidson) by admin on 20-03-2012

download
1. Put a pair of male and female clamp halves together just above the lower triple-clamp. Squeeze the ends of the clamp together with a pair of pliers. Diagram A. 2. Have an assistant position the Light Bar Assembly so the lightbar bracket is to the outside of the clamp assembly. Make sure the wires from the Light Bar Assembly are below the lower triple clamp. Diagram B. 3. Insert a Screw through the clamp and Light Bar Assembly mounting bracket and thread on an Acorn Nut. 4. Hold the Light Bar Assembly in place in front of the lower triple clamp, assemble and attach the remaining clamps. 5. With all four clamp assemblies in place, tighten the clamping screws and nuts to 15 ft. lbs. (21 Nm). Refer to the service manual to gain access to the wire harness inside the fuel tank tunnel or inside the frame backbone. Also, verify the appropriate color wires for hook-up of the passing lamps and turnsignals and running lights. Route the wires from the Light Bar Assembly, around the lower triple- clamp, and up to the frame backbone. Secure the wires so they cannot become pinched when turning the fork. A. The short black wires from the Light Bar Assembly connect to the wires powering the running lights. B. The short red wires from the Light Bar Assembly connect to the wires powering the turnsignals. C. The long blue wires from the Light Bar Assembly connect to the wire powering the headlight low beam. After the wires are connected, verify the operation of the passing lamps, running lights and turnsignals. Correct any connection problems before reassembling the motorcycle. Reinstall the fuel tank. Check all fasteners used during this installation for tightness

Incoming search terms:

HARLEY DAVIDSON TRIKE CHROME REAR GUARD KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 05-02-2011

download
INSTALLATION 1. Set the vehicle parking brake, open the trunk door and remove the trunk liners. 2. See Figure 1. From inside the trunk, locate four screws with washers (A) in the floor of the trunk compartment that hold the body to the rear frame. Leaving the washer in place, remove one of the screws and discard. 3. Obtain a long hex head cap screw (3) from the kit. Apply a few drops of Loctite – Blue to the threads of the screw, about 0.75 in (19 mm) from the screw head (C). 4. Insert the screw through the washer (A) and trunk floor. Thread it all the way through the U-channel on the outboard side of the rear frame (B), but do not fully tighten at this time. 5. Repeat for the remaining three screws. 6. Tighten all four screws to 18 ft-lbs (24.4 Nm) . 7. With an assistant, position the trunk rail assembly to the underside of the frame, fitting the four holes in the rail mounting brackets onto the threads of the screws installed in Step 4. 8. Apply a few drops of Loctite – Blue to the threads of each lock nut (4). 9. Install a washer (5) and locknut to the threads of each screw to hold the rail in place, but tighten only enough so the rail lightly contacts the frame. 10. Align the rear guard evenly to the contour of the lower body for best appearance, and adjust the position of the rail to provide clearance between the rail and the rear of the vehicle body. 11. With an assistant firmly holding the screw heads inside the trunk to keep them from turning, tighten the four lock nuts to 18 ft-lbs (24.4 Nm) . 12. Install an insert (2) into each end of the rear guard. Push firmly until fully seated.

Incoming search terms: