HARLEY DAVIDSON FORK SLIDER END COVERS INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 23-02-2011

download
INSTALLATION NOTES See Figure 4. The Fork Slider End Covers are side specific. The left side assembly (1) contains a rubber axle nut cap (4); the right side assembly (9) does not. The left side assembly also contains the letter “L” cast on the inside surface of the cover. Install the left side Fork Slider End Cover first. 1. See Figure 1. Install the rubber axle nut cap (1) from the kit over the axle nut. 2. Install the rubber axle insert (2) over the axle as shown. 3. See Figure 2. Install the rubber axle cap (1) as shown. Ensure the cap is oriented with the word “TOP” on top.

HARLEY DAVIDSON AXLE CAP NUT KIT (CHROME) INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 05-02-2011

download
INSTALLATION 1. Secure the front wheel of the motorcycle. 2. Remove one hex nut, lockwasher and flat washer attaching the axle holder to the right-side fork damper tube. 3. Assemble a chrome flat washer, split lockwasher and cap nut from the kit to the fork damper stud, but do not fully tighten at this time. 4. Repeat with the remaining nut, lockwasher and flat washer on the other stud. 5. For 2000 and later models: See Figure 1. Insert a 7/16 inch drill bit (3) into the hole in the front axle (2). Pull the right-side fork leg (1) so that it just contacts the drill bit. 1 4 2 3 is04467 1. Fork leg 2. Front axle 3. Drill bit 4. Chrome cap nut, lockwasher and flat washer (2) Figure 1. Align the Front Wheel 6. Tighten the new chrome cap nuts (4) to 9-13 ft-lbs (12-18 Nm)