HONDA VTX1800R & HONDA VTX1800N BIG SHOTS EXHAUST SYSTEM

0

Filed Under (Honda) by admin on 10-11-2011

download
harness. Remove wire tie (take note of harness routing for reassembly). Un-route wires and drape over right side of pipe. 3. Remove entire right side floorboard assembly, (three bolts) (Figure 1). 4. Remove exhaust port flange nuts.
5. Remove flange bolts securing rear muffler mount to exhaust system mounting bar. 6. Remove complete exhaust system. Start by removing front head pipe from exhaust port (assistance may be required). 7. Remove rectifier from mounting bar. 8. Remove stock (cast iron) exhaust system mounting bar.

HONDA VTX 1800C,F BIG SHOTS EXHAUST SYSTEM

0

Filed Under (Honda) by admin on 09-11-2011

download
Remove right side frame cover. 2. If motorcycle is oxygen sensor equipped, locate and unplug connector(s). Remove wire tie (take note of harness routing for reassembly). Remove sensor(s) from exhaust system. Note: Use caution when handling. Do not handle sensor tip area, store in a safe dry place for reassembly. 3. Remove allen head screw, holding rear brake master cylinder reservoir and cover. 4. Remove footpeg flange head bolts. Carefully lower right foot peg assembly, with rear brake reservoir attached. Note: Use caution when handling brake line. 5. Remove exhaust port flange nuts.6. Remove flange bolts securing rear muffler mount to exhaust system mounting bar. 7. Remove complete exhaust system. Start by removing front head pipe from exhaust port (assistance may be required). 8. Remove rectifier from mounting bar. 9. Remove stock (cast iron) exhaust system mounting bar