TOYOTA ALL MODELS BATTERY MAINTENANCE FOR IN-STOCK VEHICLES

0

Filed Under (Toyota Manuals) by admin on 16-10-2011

download
A battery in a stored vehicle is subject to conditions which can reduce its performance and life. These conditions include storage period, temperature, parasitic drain, and battery load. Because of these factors, battery inspection and maintenance are recommended in order to ensure proper operation and optimal battery life. As a matter of policy, Toyota does not provide battery warranty coverage for excessively discharged and/or failed batteries due to
lack of maintenance. It is considered the dealers responsibility to maintain the specified state of charge of the vehicle’s battery while in stock. BATTERY MAINTENANCE RECOMMENDATIONS: 1. A monthly battery inspection is recommended under normal conditions. If your dealership is located in an area subject to extreme temperatures (hot or cold), periodic maintenance may need to be performed on a more frequent basis. When maintenance requires removal of filler plugs on vehicles with “maintenance free” batteries, new labels are available via the following part numbers:

HARLEY DAVIDSON BILLET CLOCK, FRONT BRAKE MASTER CYLINDER MOUNT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 21-02-2011

download
INSTALLATION 1. See Figure 1. Clean the face of the front master cylinder reservoir with denatured alcohol and a paper towel. 2. Remove the paper backing from the adhesive strip, and line the clock up squarely to the master cylinder reservoir as shown. Press firmly into place and hold for a few seconds. 3. Let the adhesive set for a while before setting the time. SETTING THE TIME ON THE CLOCK 1. Using the hex key included in the kit, remove the two screws securing the faceplate to the clock housing 2. Lift off the faceplate and “O”-ring, and set aside. Lift the clock face and movement assembly out of the housing. 3. Pull out the stem carefully, and turn it until the hands indicate the correct time. Carefully push the stem back in to start the clock. 4. Check that the “O”-ring is in place in the faceplate, and re-install the faceplate to the clock housing. Do not over- tighten. REPLACING THE CLOCK BATTERY The clock battery (Type SR626SW) is a common type, available wherever watch batteries are sold. When storing the motorcycle for a long period, pull out the stem carefully to stop the clock and save battery life