HARLEY DAVIDSON DYNA SECURITY SYSTEM SMART SIREN II KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 23-02-2011

download
This kit fits 1996 through 2003 Dyna INSTALLATION To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables (negative (-) cable first) before proceeding. (00307a) Disconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00049a) 1. Refer to the Owner’s Manual and follow the instructions given to disarm the security system, remove the seat, and disconnect the battery cables (negative cable first). Retain all seat mounting hardware. 2 1 is 01366 1. Siren connector 2. Dust cap Figure 1. Siren Connector 2. See Figure 1. Locate the siren connector (1). It is covered by a black dust cap (2) and is at the end of an unconnected 10 inch (254 mm) long harness leg starting near the rear fender, close to the rear lighting connector. Free the siren connector from its constraints. 3. Remove the dust cap from the connector. 4. See Figure 2. Snap the siren (2) into the siren bracket (3) so that the sounder disc (4) fits the notch in the bracket as shown. Connect the siren connector (1) to the siren.