BMW F650GS Single Shock Supplement

0

Filed Under (BMW) by admin on 14-02-2011

download
Mount the shock & adjuster as you would your stock shock & adjuster per your authorized shop manual (with the rebound adjustment at the bottom) noting the following: n As you mount the shock, feed the Remote Adjustable Pre-Load adjuster through the same path as the stock line was routed to the same location. n Do not loosen or attempt to rotate the line between the shock and the adjuster. n Make sure the shock rebound adjustment is facing the right side of the motorcycle and the pressure valve is facing forward. n Tighten shock bolts to the proper torque specifications (refer to your manual). n Mount the adjuster to the supplied mounting bracket using the supplied M6-1.0X8mm SHCS fasteners and torque them to 80-90 in/lbs (9-10 N-m) as in figure 3. Then mount the bracket and adjuster to the bike in the same location as the stock preload adjuster/bracket using the stock bolts as shown in figure 4. Check banjo-bolt to cylinder clearance and adjust if necessary via tolerances in mounting bracket holes. n Using the supplied zip-ties, secure the hydraulic line away from any moving parts or heat sources. To adjust the ride height, simply turn the adjuster knob clockwise to increase the height and counterclockwise to reduce it. See main instructions for procedure of achieving optimum ride height.

2000-2007 BMW F650GS Adapter Installation Manual

0

Filed Under (BMW) by admin on 26-10-2010

download
1. Remove both of the rear stock luggage rack screws with a Torx wrench. 2. Install the Rear Frame Grabber by sliding it up under the rear fender and in front of the stock luggage rack mounting tabs. 3. Attach the Rear Frame Grabber with the 2 replacement M8 screws (stock ones are too short). The tabs on the Rear Frame Grabber should face outward toward the rear of the bike (see A in picture). Torque both screws to 110in.lbs. 4. Install the Rear Adapter as shown. 5. Attach the Rear Adapter with 2 5/16 Button Head Screws. Torque both screws to 110in.lbs. 6. Remove the motorcycle seat and remove the 2 torx screws shown in the picture. 7. Install Frame Grabber Nuts under the passenger grab bar mounts. The long end of the nut goes to the rear of the motorcycle. 8. Support the nut under the mount with your fingers and attach the Front Frame Grabber with a 5/16 Button Head Screw. 9. Reinstall the Torx screws to attach the plastic side cover of the motorcycle. There will be some overlap of the plastic cover and the Front Frame Grabber. 10. Install the Front Adapter. 11. Attach the Front Adapter with two 5/16 Button Head Screws and Locking Nuts. Snug but don’t tighten the screw until after you have installed the Front Main Arm. 12. Reinstall the Seat and compartment cover. Depending on the year of your motorcycle you may need to push the rear of the seat forward to get it around the Front Adapter. It’s a close fit, but it will fit. A B D J C E F G H F