Kawasaki 900 / 1100 Engine Removal and Installation

0

Filed Under (Kawasaki) by admin on 01-05-2012

download
1.1 (Above) Remove the two retaining straps, disconnect the battery and remove it from the hull. Disconnect the negative (black) cable first, then the positive (red). Step 2 Intake Removal 2.1 (Below) Remove the eight 10mm bolts securing the flame arrestor cover to the base and remove it. 2.2 (Below) Pull out the flame arrestor screens. 2.3 (Below) Remove the six 10mm bolts securing the flame arrestor base and carbs to the manifold and remove the base. 2.4 (Below) Loosen the gas tank cap to relieve pressure. Be sure the fuel switch is turned to the “OFF” position, and be aware of any fuel that may spill from the hoses. Make sure the hull is clear of any gasoline fumes before continuing work, especially with power tools. Remove the pulse lines from the block, and the three oil lines from the carbs. Move the carbs aside in the hull. 2.5 (Below) Remove the 18 10mm nuts from the studs securing the intake manifold to the engine and remove the manifold

Incoming search terms:

Harley-Davidson Carburetors TUNING INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 07-02-2011

download
CARBURETOR REMOVAL Edelbrock recommends consulting an authorized service manual for make, model and year of motorcycle before disassembly of stock parts. 1. Turn fuel valve off before getting started. 2. Disconnect battery to eliminate the possibility of sparks or accidentally engaging the starter. 3. Remove air cleaner assembly. 4. Disconnect choke cable from its bracket. 5. Disconnect fuel line and vacuum lines from carburetor. 6. Gently remove carburetor from manifold. NOTE: For removal of CV style carbs, Edelbrock recommends the carb be gently wiggled from side to side (not up and down) while pulling to get carb out of manifold. MANIFOLD REQUIREMENTS Edelbrock Quick Kits and Complete kits are designed to work with the stock manifold that was OE on your engine. Some aftermarket manifolds will also work with Edelbrock carburetors. S&S “E” Series and Screamin’ Eagle flange mount manifolds will work with Edelbrock flange style carburetors. It is also recommended the manifold being used closely matches the venturi of the carburetor. BIKE PREPARATION 1. Once stock carburetor and air cleaner have been removed, inspect manifold grommet (CV manifolds only) for tears, nicks or cuts. Replace grommet, if damaged. Stuff a clean dry rag into manifold until carb is installed to keep any debris out of engine. 2. Remove old fuel line and vacuum line (if equipped) and install supplied fuel line and vacuum line

Incoming search terms: