GL 1200 CB TRANSCEIVER Installation Manual

0

Filed Under (Honda) by admin on 21-11-2011

download
Remove the right and left side covers. Disconnect the battery negative cable from the battery negative terminal.
2) Remove the left fairing pocket Remove the Auto volume control unit. -1 Remove the CB blind cover from the fairing by removing the four 5 x 22 mm socket head bolts. (Fig. 2) Disconnect the three wire connectors of the auto volume unit. (Fig. 3) -2 Remove the two 4 x 12mm tapping screws and remove the knob and nut from the auto volume control unit. (Fig. 1) -3 Remove the bracket form the auto volume control unit. NOTE: Discard the CB blind cover, 4 x 22mm tapping screws, and bracket. 4) Remove the seat. 5) Remove the shelter NOTE: To remove the front of the shelter, it is necessary to remove the inner cover by lifting the rear of the cover. 6) Remove the two tapping screws attaching the left coupler cover and move the holder towards the center. 7) Remove the main amplifier. -1 Disconnect the main amplifier 2-P black connector. -2 Straighten the four wire clamps at the main amplifier to release the harnesses. -3 Remove the two nuts and washers holding the main amplifier; pull the amplifier out between the left fairing pocket and handlebar by pulling up on the bottom. 8) Connect the two DIN connectors if the transceiver harness (65) to the terminal component (62) color-to-color (Fig. 7). 9) Remove the seals from the terminal component mounts inside the fairing. Position the terminal component (62) on the mounts and install using cap nuts (69) and washers (72). NOTE: Use care when installing the terminal component (62) not to push in the audio harness, CB harness and terminal component harness into the fairing pocket

2001-2002 GL1800/ A CB Radio Replacement/ REPAIR PROCEDURE

0

Filed Under (Honda) by admin on 29-01-2011

download
For authorization, call the CB Exchange Radio Order Desk toll free: (888) 997-7278 . The CB Exchange Radio Order Desk hours are Monday thru Friday, 8:30am – 8:00pm EST. BEFORE STARTING ANY REPAIR ON THE CB RADIO, YOU MUST FIRST CALL THE ORDER DESK FOR AUTHORIZATION. Part Number: 08E95-MCA-101RM Honda Code: 7066319 3. After calling the CB Radio Order Desk, an exchange transceiver will be shipped overnight (freight prepaid). 4. Replace the faulty CB Transceiver with the exchange unit (see REPAIR PROCEDURE ). . Remove the seat (see the GL1800 Service Manual, page 2-4). 2. Remove the right rear side cover (page 2-4). 3. Remove the right-hand fairing molding (page 2-8). 4. Remove the right hand top shelter setting bolts and mounting nut (page 2-9). It is not necessary to remove the left-hand fairing molding, shelter bolts, or shelter. 5. Disconnect the 14P CD coupler under the rear seat. Remove and set aside the CD Changer (if equipped). (Continued on page 2) Some customers may experience weak radio transmissions and/or the need to use abnormally high squelch settings for reception on the Hondaline CB Radio. To correct this condition, the CB Transceiver unit must be replaced as described in this Service Bulletin. Do not order a CB kit from parts stock. Follow the ordering procedures in this Service Bulletin. AFFECTED MOTORCYCLES 2001 – 2002 GL1800/A ORDERING AND REPLACING THE CB TRANSCEIVER 1. Before calling the CB Exchange Radio Order Desk, have the following information ready: • VIN • Failure Information (i.e., symptom) • Warranty Status 2. For authorization, call the CB Exchange Radio Order Desk toll free: (888) 997-7278 . The CB

Incoming search terms: