2002-2003 GL1800 BANK ANGLE SENSOR MOUNTING SCREW REPAIR PROCEDURE

0

Filed Under (Honda) by admin on 29-01-2011

download
1. Insert the ignition key into the lock cylinder and open the fairing pocket lid by turning the key clockwise. Remove the two trim clips by pushing the center pins in. Remove the two screws. Disconnect the opener cable and remove the right fairing pocket. 2. To access the bank angle sensor, remove the two mounting screws securing the connector holder. Place the holder to the side. 3. To check for the proper screw size, slightly tighten both bank angle sensor screws. If the screws are tight, reassemble the unit and apply the identification mark. If the screws spin in the holes, proceed to Step 4. 4. Using a magnetic screwdriver, remove and discard one of the two 4 mm screws securing the bank angle sensor assembly. Replace with a 5 x 12 mm self-tapping screw (see the PARTS INFORMATION section on page 3 for the proper screw for this repair). Repeat for the other screw. 5. Reinstall the removed parts in the reverse order of removal. IDENTIFICATION Apply a white paint dot in the center of the underside of the right fairing pocket lid as shown. This will indicate that the Safety Recall has been performed on this unit

GL 1800 led fairing lights INSTALLATION

0

Filed Under (Honda) by admin on 27-10-2010

download
steP 1 Read and understand all steps in the instructions before starting the installation. Park the motorcycle on a hard, level surface and turn off the ignition. ATTENTION! A factory service manual may be helpful in performing this installation. Do not attempt to perform this installation if you are not confident in your ability to complete all of the steps in the procedure; consult a trained technician. steP 2 Remove the side cover on the clutch side as shown in PIC. 1, by gently pulling on it to release the bosses securing the cover. steP 3 Carefully remove the clutch side fairing-molding piece shown in PIC.2 starting at the bottom of the molding; pulling out to disengage the tabs, working your way up the piece. steP 4 Open the clutch side fairing pocket lid, and remove the four trim clips by pushing in on the center pins, and then pulling the clips out. Set the trim clips aside, as they will be used to reinstall the fairing pocket. (PIC.3) steP 5 Remove the fairing pocket by pulling it straight up and out. steP 6 Remove the rubber grommet from the bottom of the fairing pocket and set aside for now. (See PIC.3.) steP 7 Remove the three bolts from the front fairing as shown in PIC.4; set them aside to reinstall later. steP 8 Remove/disconnect the inline fuse on the power wire (red) and insert through the hole in the bottom of the fairing pocket, so that the controller switch will be located in the fairing pocket. steP 9 Carefully insert the remaining wires one at a time, from the control switch through the hole in the bottom of the fairing pocket.