TOYOTA TACOMA (ALL 4WD, 2WD PRERUNNER, & 2WD TRD MODELS) 3" SUSPENSION LIFT KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Toyota Manuals) by admin on 27-09-2011

download
Before Starting Installation 1. Carefully read all warnings and instructions completely before beginning. 2. Verify all parts have been received in this kit by checking the parts list at the end of this document. 3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what is outlined in the instructions, call technical support at (928) 636-3175. 4. Special tools needed: a. Coil spring compressor 5. Park vehicle on a clean, dry, flat, level surface and block tires so vehicle cannot roll in either direction. Ride Height 1. Measure ride height with the vehicle supporting its own weight on level ground. To settle the suspension, the vehicle should be driven forward at least 10 feet immediately prior to taking these measurements. Ride height is the measurement from the NOTE Kit parts are prefaced by the word kit and appear in bold print. NOTE Adhere to recommendations when replacement fasteners, retainers and keepers are called out in the factory service manual. When re-assembling the vehicle it is recommended by the vehicle manufacturer that certain fasteners are replaced in order to maintain proper retention characteristics. This system may not include all replacement hardware as recommended by the factory service manual. Additional replacement hardware should be obtained prior to installation of this system to meet the requirements of the factory service manual

TOYOTA CELICA SPORT COIL SPRINGS (STREET)

0

Filed Under (Toyota Manuals) by admin on 06-06-2011

Download
Use a 13mm and 10mm socket or wrench to loosen and remove the bolts holding the brake lines to the strut. Retain the hardware for later re-installation. 4) Use a 21mm and 22mm socket or wrench to loosen and remove the two bolts holding the base of the strut to the spindle. Use a 12mm socket or wrench to loosen and remove the nuts retaining the top of the strut. The strut will now be free and can drop out of the vehicle. Use caution to avoid dropping the strut, as this could damage the strut or the vehicle. 5) Place one of the struts into the coil spring compressor and collapse the spring until the upper strut plate is no longer under tension. Remove the plastic dust cover on the top of the strut. Use a 19mm socket and a 6mm Allen wrench to remove the retaining nut at the top of the strut. Retain the hardware for later Re-installatio