2007 Corolla & Matrix 1ZZ-FE ENGINE NO START CONDITION REPAIR

0

Filed Under (Toyota Manuals) by admin on 01-11-2011

download
Refer to TIS, 2007 model year Corolla or Matrix Repair Manual: Engine Hybrid System – Engine Control – “1ZZ-FE Engine Control System: ECM: Removal” Engine Hybrid System – Engine Control – “1ZZ-FE Engine Control System: ECM: Installation” 2. Register the VIN into the replacement ECM (PCM). Refer to TIS, 2007 model year Corolla or Matrix Repair Manual: Engine Hybrid System – Engine Control – “1ZZ-FE Engine Control System: SFI System: Registration Some 2007 model year Corolla and Matrix vehicles equipped with a 1ZZ-FE engine may exhibit a “no start” condition. Improvements have been made to the Engine Control Module (ECM) (SAE term: Powertrain Control Module/PCM) manufacturing process to reduce the possibility of this condition occurring. Please use the following procedure to repair the vehicle

Incoming search terms:

2003 – 2005 Corolla HEATER PERFORMANCE IMPROVEMENT REPAIR

0

Filed Under (Toyota Manuals) by admin on 30-10-2011

download
Install the SST to the piping clamp. SST: 09870-00015 HINT: Confirm the direction of the piping clamp claw and the SST using the illustration shown on the caution label. B. Push down the SST and release the clamp lock. NOTE: Be careful not to deform the tube when pushing the SST. C. Pull the SST slightly and push the release lever. Then remove the piping clamp with the SST. D. Remove the piping clamp from the SST. E. Disconnect the cooler refrigerant suction hose No. 1. NOTE: Disconnect the tube by hand only. Do not pry the tube apart. Cap the open fittings immediately to keep moisture or dirt out of the system

TOYOTA AUTOMATIC TRANSMISSION SHIFT LOCK OVERRIDE BUTTON

0

Filed Under (Toyota Manuals) by admin on 14-10-2011

download
AUTOMATIC TRANSMISSION SHIFT LOCK OVERRIDE BUTTON 2/3 ORB COVER STORAGE: The ORB is placed in a plastic envelope with a caution label and the envelope is taped to the automatic transmission shift lever as shown below: INSTALLATION OF ORB COVER: Install the ORB cover with the index facing toward the rear of the vehicle. PRODUCTION EFFECTIVE: MODEL PRODUCTION EFFECTIVE CAMRY FROM ’93 M/Y (AUGUST, 1992) COROLLA FROM ’93 M/Y (JUNE, 1992) TERCEL, PASEO FROM ’93 M/Y (AUGUST, 1992) CELICA FROM ’93 M/Y (AUGUST, 1992) LAND CRUISER FROM ’93 M/Y (AUGUST, 1992) TMM CAMRY FROM ’93 M/Y (AUGUST, 1992) TMMC COROLLA FROM ’93 M/Y (SEPTEMBER, 1992) NUMMI COROLLA FROM ’93 M/Y (AUGUST, 1992

Incoming search terms:

2004 – 2005 Camry, Highlander, And Solara, 2005 Matrix & Corolla PASSENGER AIRBAG INDICATOR LAMP

0

Filed Under (Toyota Manuals) by admin on 10-10-2011

download
passengers weighing approximately less than 100 pounds, depending on their seating position. It is important for the front seat passengers to know that proper operation of the advanced frontal airbag system is highly dependent on the pressure placed on the seat bottom. Situations that add or subtract sensed weight can result in occupant misclassification. To minimize this situation: Check seating posture. Passengers should be seated upright with their back against the seat back and feet on the floor. Check loading conditions. Extra weight from items, such as bags or groceries or toys, hanging on the seat back can add to the sensed weight of the front seat passenger. A rear seat passenger lifting the front seat with their legs, objects placed under the front seat, or the front seatback in contact with the rear seat can subtract from the sensed weight of the front seat passenger. If the passenger airbag indicator lamp continues to switch ON to OFF after checking the above conditions, perform the following repair procedure. NOTE: The safest place for children is in the rear seat. Please note that Toyota recommends that you never install a rear-facing child restraint in the front passenger seat, even if the passenger “Airbag OFF” lamp is illuminated. Please refer to you Owner’s Manual for additional details. 2004 – 2005 model year Camry, Highlander, and Solara vehicles produced BEFORE the Production Change Effective VINs shown on the following page. 2005 model year Matrix and Corolla vehicles produced BEFORE the Production Change Effective VINs shown on the following page

Incoming search terms:

TOYOTA A/ C LIGHT FLASHING MAGNETIC CLUTCH RELAY

0

Filed Under (Toyota Manuals) by admin on 09-10-2011

download
01 – ’04 Camry, ECHO, & Celica ’02 – ’04 4Runner, Corolla, & MR2 Spyder ’03 – ’04 Highlander, Matrix, Sienna, & Solara Technical Service BULLETIN June 3, 2005 This bulletin is to provide information regarding countermeasures to the A/C magnetic clutch relay for A/C light flashing (inoperative A/C) issues on some vehicles equipped with a magnetic clutch compressor. 2001 – 2004 model year Camry, ECHO, and Celica vehicles. 2002 – 2004 model year 4Runner, Corolla, and MR2 Spyder vehicles. 2003 – 2004 model year Highlander, Matrix, Sienna, and Solara vehicle

Toyota Automatic Transmission Serial Number Locations

0

Filed Under (Toyota Manuals) by admin on 07-10-2011

download
2006-2009 4Runner, Avalon, Camry, Corolla, FJ Cruiser, Highlander, Land Cruiser, Matrix, RAV4, Sequoia, Sienna, Solar a, Tacoma, Tundra, Venza, Yar is TSB SUPERSESSION NOTICE The information contained in this TSB supersedes TSB No. TC012-06. •Applicability has been updated to include 2008-2009 model year vehicles. TSB No. TC012-06 is Obsolete and any printed versions should be discarded. Be sure tore view the entire content of this service bulletin before proceeding. Introduction The purpose of this TSB is to assist in the identification and location of serial numbers on 2006 -2009 modelyear automatic transmissions

1988 Toyota MANUAL TRANSMISSION SERVICING

0

Filed Under (Toyota Manuals) by admin on 18-09-2011

Download
Camry, Celica, Corolla, Cressida, MR2, Pickup/4Runner, Supra, Tercel, Van/Wago to bottom of hole. Transmission on Tercel Wagon has 2 drain plugs on bottom of transaxle.Transfer Case (Except Tercel Wagon) Drain plugs on 4WD transfer cases are separate from main transmission case. Transfer Case (Tercel Wagon) The integral differential and transaxle assembly on Tercel Wagons have separate drain and fill plugs. See Fig. 1. When filling with fluid, leave extension housing drain plug loose about 7 or 8 turns. After filling, tighten drain plug.

Incoming search terms:

How to Replace your starter : 99 Corolla VE

0

Filed Under (Toyota Manuals) by admin on 17-06-2011

Use a 10mm ratchet attachment to remove the battery from the vehicle. Negative terminal first, then positive. Be careful not to cause an arc between the two terminals as intense pain will result.
Remove the plastic plate that the battery sits in. 2. Using the 10mm attachment again, remove the 6 bolts that hold the passenger side front splash guard from underneath the front bumper. 3. From underneath the vehicle, locate the oil filter. Look above oil filter and you will see the starter. Locate the bottom 14 mm bolt that attaches the lower portion of the starter to the engine. The bolt drives from left to right. The starter is mounted toward the front of the vehicle and underneath the intake manifold. Still cant find it?
Follow the cable that leads from the positive battery terminal. It ends at the starter. Not sure you have the right bolt? Stick your 14mm attachment on it with your fingers and see if it fits on properly

2003 – 2004 Corolla EXCESSIVE SULFUR DIOXIDE ODOR

0

Filed Under (Toyota Manuals) by admin on 13-06-2011

Download
Some customers may complain of excessive sulfur dioxide odor on 2003–2004 model year Corolla vehicles under the following conditions: S Stop and go driving. S Heavy acceleration. In order to reduce the sulfur dioxide odor, the Electronic Control Module (ECM) (SAE term: Powertrain Control Module/PCM) fuel cut control logic has been modified and a new catalyst is provided. Follow the repair procedure to reflash the ECM and replace the catalytic converter assembly.

Corolla & Matrix 2005 – 2006 1ZZ-FE ENGINE NO START OR EXTENDED CRANK CONDITION

0

Filed Under (Toyota Manuals) by admin on 29-05-2011

Download
Some 2005 and 2006 model year Corolla and Matrix vehicles equipped with a 1ZZ–FE engine may exhibit a “no start” or “extended crank” condition. This may be caused by insufficient fuel pressure after the vehicle has been parked for a period of time. The fuel pump assembly manufacturing process has been improved to correct this condition. Applicable Vehicles S 2005 – 2006 model year Corolla and Matrix (2WD) vehicles equipped with the
1ZZ–FE engine. Parts Information PREVIOUS PART NUMBER 77020–02180 77144–04010 77169–02050 CURRENT PART NUMBER Same Same Same PART NAME Fuel Suction w/Pump & Gauge Tube Assembly Fuel Pump Gauge etainer
Fuel Suction Tube Set Gasket

Incoming search terms:

Incoming search terms: