Harley-Davidson DETACHABLE SISSY BAR SIDE STRAPS INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 20-04-2012

download
1. Remove factory sissy bar upright. Save upright if to be reused. Remove the two factory buttonhead screws and washers from the fender support on each side. Remove factory side plates. Discard side plates and factory hardware. 2. Cement the Plastic Sliders (item #1) into the brackets on the Khrome Werks Side Straps (item #2), using contact glue. 3. Install the special buttonhead screws through the flanged spacers (items #7, 8), then through the fender supports, frame, and into the fender. 4. Assemble the Knurled Knob (item #6) to the Side Strap, using the 1⁄ 4 “-20 x 1⁄ 2 ” screw, chrome washer and compression spring (items #3, 4, 5). The spring goes under the washer and into the counterbore of the knurled knob. 5. Install your sissy bar upright into the Side Straps, using the 1 ⁄ 4 “-28 x 3⁄ 4 ” screws provided (item #9).

HARLEY DAVIDSON HEEL/TOE SHIFT LEVER KITS INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 18-03-2011

download
INSTALLATION NOTE The shift levers in these kits have opposite counterbored screw holes. When the toe and heel levers are positioned correctly, the socket head cap screws will be installed from the bottom of both levers. 1. Before removing the original shift levers, note the orientation. You may want to replace them at the same position and angle. NOTE The original equipment shift levers may have the socket head screws that secure the shift levers to the splined shifter shaft installed from the top or bottom, depending on your model motorcycle. 2. See Figure 1. Remove the original equipment shifter pegs (A) and retain for re-attachment to the new levers if desired. Remove the socket head screws (3) that clamp the shift levers onto the splined shifter shaft. Remove the original equipment shift levers. 3. First, position the toe shifter lever (1) so the counterbored screw hole is at the bottom. Slide the toe shifter lever onto the splined shifter shaft and position to the desired angle, aligning the screw hole with the notch on the shaft. 4. Install the heel shift lever (2) with the counterbore at the bottom. 5. Add a few drops of Loctite® 243 (blue) to the socket head screws (3), and insert the screws into the counterbored holes. Tighten to 24-26 ft-lbs (32-35 Nm) . 6. Install the shifter pegs onto the new shift levers. If using the original pegs, place a few drops of Loctite blue onto the screw threads prior to installation. Tighten the shifter peg screws. 7. Check for proper operation and clearance

Incoming search terms: