HARLEY DAVIDSON CHROME 4-CHANNEL LUGGAGE RACK INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 24-02-2011

download
INSTALLATION Do not exceed luggage rack weight capacity. Too much weight can cause loss of control, which could result in death or serious injury. (00373a) NOTE Maximum luggage rack weight capacity is ten pounds (4.5 Kg). Luggage Rack Assembly 1. See Figure 1. Locate inner channels (1) by rounded cuts (2) on one end. Lay inner channels side by side on a flat table with the cutout end flush with the edge. Verify that the cutouts face outside in opposite directions. 2. See Figure 2. Place the backrest support slide bars (1) inside the inner channels with the tapped holes on the cutout end of the inner channels. 3. Separate spacers by their length, two 5/16 inch, four 3/4 inch and six 1-1/16 inch. Set two 5/16 inch spacers aside, they will be used later. 4. Position the four 3/4 inch spacers (2) inside the backrest support slide bars.

HARLEY DAVIDSON CHROME UPPER BELT GUARD KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 03-02-2011

download
INSTALLATION NOTE When performing the following step, it is not necessary to completely remove the shock mount bolt, back the bolt out only until it is flush with the swingarm. 1. See Figure 1. Loosen the left rear shock mount bolt (1) and back it out until the threaded portion of the bolt is flush with the swingarm. 1 2 is03762 1. Shock mounting bolt (left side) 2. Belt guard Figure 1. Loosen Shock Mounting Bolt 2. Pull the belt guard (2) straight back toward the rear of the bike to remove the guard from upper and lower grommets. See Figure 2. It may be necessary to work the guard up and down slightly to dislodge it from the upper (1) and lower (2) grommets. Remove the belt guard and discard. 2 1 3 is03763 1. Upper grommet mount 2. Lower grommet mount 3. Front belt cover Figure 2. Rubber Grommet Mount Locations 3. Obtain the chrome belt guard from kit. While making sure belt guard is over the belt, slide the guard straight in between the shock and sprocket and align cover just below front belt cover (3). The cutouts in the bracket should be lined up to engage with upper and lower grommets. NOTE When performing the following step, gently pull the guard in and out at the center; it should feel fairly tight even though the rear mounting bracket has not been secured. 4. See Figure 3. Firmly push the guard toward the front of the bike until the cutouts are secured by the grommets and the belt guard mounting bracket (1) hole lines up with the shock bolt