RAPID PULSE HORN OR LIGHTING MODULATOR INSTALLATION MANUAL

0

Filed Under (Tips and Review) by admin on 23-12-2010

download
this module will pulse any horn, headlight or tail light at the rate of 7 times per second. 1. Find a suitable mounting location. Clean the mounting surface thoroughly using rubbing alcohol, peel the adhesive backing and press the module firmly in place. 2. Connect the black wire to the frame or other suitable ground. (NOTE: Failure to achieve a good ground will ruin the module Immediately and void the warranty!) 3. At any point that is convenient cut or disconnect the power wire to the light or horn(s). Connect the green wire to the wire going to the light, horn(s) or wire going to it. 4. Connect the red wire to the power wire coming from the motorcycle. 5. To bypass or turn the modulator off (in some states it is not legal to use a headlight modulator at night or at all, check your state laws) install an on/off switch between the red and green wires. When the switch is in the on position the electricity to the light or horn(s) will bypass the module and the light or horn(s) will not pulse.

YAMAHA FZR 400 ELECTRICAL CIRCUIT DIAGRAM

0

Filed Under (Yamaha) by admin on 29-11-2010

download
CHECKING OF SWITCHES Check the switches for the continuity between the terminals to determine correct connection. Read the following for switch inspection. SWITCH CONNECTION AS SHOWN IN MANUAL The manual contains a connection chart as shown left showing the terminal connections of the switches (e.g., main switch, handlebar switch, brake switch, lighting switch, etc.) The extreme left column indicates the switch positions and the top line indicates the colors of leads connected with the terminals in the switch component. “C’&-0″ indicates the terminals between which there is a continuity of electricity; i.e., a cl.osed circuit at the respective switch positions. In this chart: “R and Br” and “L/W and L/R” are continuous with the “ON” switch position. “B and B/W” is continuous with the “OFF” switch position. “B and B/W” is continuous with the “LOCK” switch position. “B and B/W” and “R and L/R” are continuous with the “P” switch position. CHECKING SWITCH FOR TERMINAL CONNECTION Before checking the switch, refer to the connection chart as shown above and check for the correct terminal connection (closed circuit) by the color combination. To explain how to check the switch, the main switch is taken for example in the following