TOYOTA TACOMA 2008 – INTERFACE KIT FOR IPOD REPAIR

0

Filed Under (Toyota Manuals) by admin on 01-11-2011

download
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. These guidelines can be found in the “Accessory Installation Practices” document. This document covers such items as: • Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.). • Safety (eye protection, rechecking torque procedure, etc.). • Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). • Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). Please see your Toyota dealer for a copy of this document. 1. Vehicle Protection. (a) Place driver seat in mid position. (b) Set emergency brake. (c) Remove the negative battery cable. (Fig. 1-1) (1) Protect the fender before starting. CAUTION: Do not touch the positive terminal with any tool when removing cable. (d) Using protective blankets cover front seats, interior of vehicle and center console and front side of the shift lever. (e) Wait 90 seconds before proceeding to disassemble vehicle. 2. Disassembly of Vehicle. NOTE: Place all removed parts on a protected surface. NOTE: When disconnecting wiring connectors, do not pull on the wiring; pull on the connector only. (a) Remove air conditioning control assembly (L,R). (Fig. 2-1) (1) Apply protective tape. (2) Using a panel remover, disengage the four (4) clips and remove the air conditioning control assembly

Incoming search terms:

2007 Toyota Tundra, 2WD & 4WD InstallatIon GuIde

0

Filed Under (Uncategorized) by admin on 28-09-2011

COMPRESSED AIR CAN CAUSE INJURY AND DAMAGE TO THE VEHICLE AND PARTS IF IT IS NOT HANDLED PROPERLY. FOR YOUR SAFETY, DO NOT TRY TO INFLATE THE AIR SPRINGS UNTIL THEY HAVE BEEN PROPERLY SECURED TO THE VEHICLE. 1. Jack up the rear of the vehicle using a jack or a hoist. Support the rear axle with jack stands and remove the rear wheels (fig. 2). Installing the loadlifter 5000 system TOOLS LIST Description .Qty Hoist or floor jacks . 1 Safety stands 2 Safety glasses 1 Torque wrench 1 5/16″ open-end or box wrench1 7/16″ open-end or box wrench.1 9/16″ open-end or box wrench1 Crescent wrench 1 Description  . . . . . . Qty Ratchet with 9/16″, metric, & 1/2″ deep well sockets  1 5/16″ drill bit (very sharp) 2 Heavy duty drill1 Hose cutter, razor blade, or sharp knife 1 Air compressor or compressed air source  1 Spray bottle with dish soap/water solution  1 DANGER 2. Bend the emergency brake cable bracket forward slightly on both sides of the vehicle (fig. 3). 3. It will be necessary to trim the stock jounce bumper to gain clearance for the air spring assembly’s lower bracket. Measure up from the base ¾” and mark a line on the jounce bumper. Using a box cutter or equivalent, cut the top of the jounce bumper off (fig. 3). USE ExTREME CAUTION WHEN CUTTING OFF THE JOUNCE BUMPER WITH THE CUTTING TOOL. CAUTION

Incoming search terms: