2008 Harley Davidson Touring models with an electronic throttle Grips Installation manual


Filed Under (Harley Davidson) by admin on 08-03-2012

1. Using a sharp knife, remove the rubber from your current grip by carefully cutting it away from the existing plastic throttle sleeve. The rubber that is adhered to the plastic sleeve must be ” shaved” resulting in a smooth plastic sleeve with no rubber. 2. Apply glue to the throttle sleeve. Use about 1/4 of the tube of glue on each side. Most of the glue should be applied to the end of the sleeve away form the throttle housing. 3. Slide the grip on to the throttle sleeve with one strong push. Use a rubber mallet if needed. Be sure not to get any of the glue into the space between the throttle sleeve and the throttle housing as well as the space between the throttle sleeve and the handlebar. *Wipe up any excess glue immediately