Harley-Davidson 39mm Fork FXR, FXD, XL from 87 to Current, Light Bar N935 & N935E INSTALLATION AND OWNER'S MANUAL

0

Filed Under (Harley Davidson) by admin on 09-03-2012

download
1. Remove Headlight from Headlight Shell (Screwdriver) set aside. 2. Disconnect Turnsignal wires behind or inside Headlight Shell. 3. Unbolt Headlight Shell from Eyebrow (3/4″ Socket & Wrench). Let hang from wires. 4. Remove front Turnsignal Assemblies from motorcycle. 4a. If Turnsignals are mounted to the Handlebar use the 1/2″ Wrench. 4b. For fork mounted Turnsignals, 1996 to current, use the Torx Wrench 4c. For fork mounted Turnsignals 1987-92 use the 5/16 Hex Key Set turnsignals aside, they will not be reused. 5. Remove screw from Brake Hose Clamp and Clutch Cable Guide (Hex Key Wrench, 3/16″) located on the bottom of the lower Triple Clamp. Set aside, it will not be reused. 6 . Remove the Pinch Bolts from the lower Triple Clamp (Torx Wrench, 1993 to Current, or 5/16 Hex Key, 1987 to 92). Set aside, they will not be reused. INSTALLATION 1. Mount the Light Bar Assembly: A. Hold the Light Bar assembly up to the lower Triple Clamp, the center bracket will be below the Triple Clamp. B. Start the 1/4-20 x 3/4 Screw, with Washer, through the Brake Hose Clamp, clutch cable guide then the center bracket and into the threaded hole previously used for the Brake Hose Clamp. C. Position a Spacer between the Outer Brackets and the Triple Clamp and start the 3/8-16 x 2″ Hex Bolts through the Outer Bracket, then the Spacer and into the Pinch bolt location on the lower Triple Clamp. Do this on both sides of the lower Triple Clamp.

YAMAHA XVS 1300 A INSTALLATION AND OWNER'S MANUAL

0

Filed Under (Yamaha) by admin on 13-01-2012

download
Place motorcycle on flat and level ground with side stand securely in place. Before installing fasteners we recommend you apply a small amount of Loctite ®medium strength #243 thread retaining compound (or similar brand) to the threads of the button head screws (a) referenced on page 3 and to the M8 x 50 fasteners supplied in Bag 914. (Thread Lock) INSTALLATION OF EYEBROW 1. Start on right side of the motorcycle and remove the 2 bolts from the fender and trim rail. Remove rear trim rail. Store bolts and trim rail, they will not be re-used. (5mm Hex Wrench) SPOOL ASSEMBLY, FRONT AND REAR 2. Assemble front and rear spool assemblies into the right eyebrow (4) and fender. Do not fully tighten. This will allow some movement which aids in the side plate installation. (5mm Hex Wrench) Figure 1. After final assembly fender mount screws will torque to: 22 Nm (17 ft/lb) 3. Repeat steps 1-2 for the left side fender assembly