Harley Davidson HOGPRO DEUCE 200 TIRE INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 18-04-2012

download
1. Remove the seat 2. Remove the rear wheel. 3. Drain and remove the primary covers and drive belt. 4. Install the new supplied 13/16″ drive belt. 5. Re-install the primary covers, gasket, seal, and fluid. 6. Remove chrome fender strut covers. 7. Remove the plastic license plate mount and un-plug the turn signals 8. Remove the rear fender 9. Discard the long gold colored wiring covers from both sides of the inner fender. 10. Wash the inside of the fender thoroughly with soap and water. 11. Clean the inner fender along the wiring path with supplied alcohol. 12. Locate the wiring harness at the top right of the fender. 13. Firmly affix the 5 supplied zip holders along the wiring path. 14. Attach the harness using the supplied zip ties. Leave enough slack so that you can adjust the position of the harness once the fender is re-installed. 15. Re-install the fender using the supplied hardware. (The curved fender mounting brackets will be re-installed from the inside out using the 4 thin supplied nyloc nuts and washers. 16. Install the front license plate mount bolts inside out using the 2 supplied nylocs and washers. 17. Tighten the fender. Using a hack saw or cut off wheel, remove the remaining threaded studs flush with the nyloc nut on each of the fender brackets. 18. Re-install your chrome fender struts. 19. Adjust the wiring harness and tighten the zip ties. Cut off the excess zip tie. 20. Install the new Hogpro wheel, pulley, and the 200 tire of your choice. 21. Have Fun!

2008 Kawasaki KFX 450 Fuel Management Interface INSTALLATION MANUAL

0

Filed Under (Kawasaki) by admin on 25-10-2010

download
1. Remove the seat. 2. Remove screws that hold on plastic gas tank cover on the left and the right side. (figure 1) 3. Remove bolts from sub-frame that hold on shrouds on the left and right side. (figure 2) 4. Remove bolts that hold on lower part of shroud connect to front fender brackets on left and right side. (figure 3&4) 5. Remove bolts connecting front body to frame on left and right side. (figure 5&6) 6. Disconnect fuel hose from gas tank. (figure 7) 7. Pull gas tank forward and disconnect the plastic connector. (figure 8) 8. Remove gas tank and plastic protector exposing fuel injector plug. 1 Instruction sheet 1 Adhesive backed Velcro square 1 FMI 3 Zip ties 2 Motoworks stickers 18550 Minthorn Street, Lake Elsinore, CA 92530 (951) 587-9222 (951) 296-1552 fax
9. Mount Motoworks FMI to plastic underneath the seat using Velcro. (figure 9) 10. Run Wires along either side of the sub frame as shown in figure 11. Route the ground wire and connect to the silver bolt on frame. (figure 10) 12. Locate fuel injector plug . (figure 11) 13. Connect the female connector into the fuel injector. 14. Connect in the original connector you removed from the fuel injector into the short pigtail male connector. 15. Reinstall quad