Honda CBR 600 F4i 2004 – 2005 Bestem USA Fiberglass F13 Installation Guide

0

Filed Under (Honda) by admin on 20-11-2011

download
We highly recommend having a professional install this undertail. A dremel tool or nsimilar is what we found the best to cut plastics. Place bike on a rear wheel center stand. Remove passenger seat and hardware which secure stock undertail section Unplug the harness that connects tail light and remove the stock undertail. Position Bestem undertail close to the bike and determine the amount of plastic needs to be cut out. Use a dremel tool to carefully trim off plastics (glove boxes etc). This is the most time consuming part of the installation but your patience will be paid off. 5) Once the new undertail is slide in, determine holes need to be drilled (only on
certain models). Reuse the hardware for the stock undertail to secure the new undertail. 6) The wiring color codes from two round tail lights are Black Wire – Ground, connects to Ground wire. Red Wire – Brake Light, connects to brake light. Blue Wire – Running Light, connect directly to the running light. Orange Wire – Turn Signal, connect them to your L/R turn signal wires We highly suggest you solder the connections and use heat shrink wrap to seal the connections. Test your lights before going out for a ride, also make sure your new undertail is securely installed on the bike. Now it’s time to go out for a spin!

CRUISADER Motorcycle Laser-Radar Detector Installation Instructions

0

Filed Under (Tips and Review) by admin on 29-01-2011

download
Installation of Laser-Radar Antenna 7 General Information The laser-radar antenna is water resistant and designed to be mounted on a motorcycle, snowmobile, etc. Radar signals will pass through non-metallic materials such as fiberglass and plastic, however, be sure not to mount the receiver behind any metal, as it will block the receiver’s antenna. This receiver also incorporates a laser detector. In order for the laser receiver to “see”, it can not be mounted behind any object. In some installations, this is not possible. We supplied an additional laser only receiver for this instance. If the installation allows for a clear view for laser-radar receiver, the extra laser receiver can be used for rear detection. Because the optimallocation for mounting the antenna varies by vehicle type, the hardware supplied is designed to offer a wide variety of mountingoptions. Note: The “antenna” is the bubble area on the case. All references to antenna in this manual will be thebubble area. Note: Use of hardware that is not supplied or DRILLING into the case will cause damage to the receiver and void the warranty. Antenna Mounting Brackets There are 3 ways in which to mount the laser-radar antenna; dual lock fastener, reflector bracket and universal brackets (similar to old car radio ground straps). These mounting accessories can be used on their own or in combination to provide the best mounting solution for the vehicle. Do not drill into the receiver housing! The reflector bracket serves two purposes; (1) to allow vertical mounting of the antenna (see page 10 for vertical install instructions) and (2); when mounted in reverse (angled portion towards the wires.) allow the receiver to be installed on any horizontal area.