DAZON RAIDER CLASSIC OWNER'S MANUAL

0

Filed Under (Dazon) by admin on 28-11-2010

download
Tires: Use a gauge to check the air pressure. Adjust if needed. Also look for signs of damages or excessive wear. z Nuts & Bolts : Check the wheels to see that the axle nuts are tightened. Use a wrench to make sure all accessible nuts, bolts, and fasteners are tight. z Underbody & Exhaust System: Check for and remove any dirt, vegetation or other debris that could be fire hazard or interfere with the proper operation of the BUGGY. z Air Cleaner Housing Drain Tube: Check for carbon deposits in the drain tube. If necessary, clean the tube and check the air cleaner housing. z Leaks, Loose Parts : Walk around your BUGGY and look for anything that appears unusual, such as a leak or loose cable. z Lights : Make sure the headlight, brake light and taillight are working properly. z Throttle : Check the free play and adjust if needed. Press the throttle to make sure it moves smoothly without sticking, and snaps back automatically when it is released. z Brakes : Press the rear brake pedal several times, check for proper brake pedal free play. Make sure there is no brake fluid leakage. z Engine Stop Button : When engine is running, press and hold the Engine Stop Button for two seconds. Make

42MM MIKUNI FLATSLIDE CARBURETOR INSTRUCTIONS

0

Filed Under (Mikuni) by admin on 31-10-2010

download
To install, remove the stock carb per Yamaha shop manual procedures. Remove stock throttle cables. Install Mikuni HSR carb into intake manifold and tighten manifold clamp. Install new HSR series throttle cables and adjust cable slack per Yamaha shop manual procedures. Hook fuel line to HSR carb and fasten clamp.* Start motorcycle and fine tune HSR carb for proper running per supplied Mikuni tuning manual. *NOTE: Mikuni HSR series carburetors are designed for gravity-feed fuel systems. You should bypass your stock fuel pump and directly feed your HSR carb right from the fuel petcock. We have noted, though, that you may not be able to get good fuel flow from your Road Star fuel tank in low-fuel situations. You may run your stock fuel pump with the HSR carb, but to do so requires the purchase and installation of an adjustable fuel pressure regulator (set at 1/2 to 1 lb. of pressure). These are available from most auto parts stores. The stock carb has 2 wires running to the lower rear of the float bowl , these were for a carb warmer, they are not used in this application. Unplug these wires at the main wire harness and retain with your stock carb. The Road Star ignition system uses data from the stock throttle position sensor (TPS) to manage your ignition timing. It is necessary to give the bike this information. You may do so by removing the TPS sensor from the stock carb, leaving it plugged into the main wire harness (the sensor must be fixed to a closed-throttle position), or you may locate the plug for the TPS on the main wire harness and test the leads – you will find one ground, one with .5V and one with 1.5V. Connect the 1.5V to the ground and this will give the bike the same information as stock fully closed throttle. The output of the OEM fuel pump is too high and will cause fuel overflow in the HSR carb, resulting in a possible dangerous fire hazard

Incoming search terms: