HERO HONDA CD-100 / SS100 / SLEEK / SPLENDOR / PASSION

0

Filed Under (Honda) by admin on 14-11-2011

download
1500 91255-169-003 30-42-11 FRONT FORK SEAL (S/S) (SLEEK) Improved Quality 200 20 PCS
1500A ————— SET OF 2 PCS FRONT FORK DUST SEAL (S/S) 100 10 PCS 1501 90756-198-000 7-37-7.5 FRONT FORK TRIPLE (COLLER) (CD-100) 200 20 PCS 1502 91202-302-01013.8-24-5 KICK SHAFT 200m20 PCS 1502A 91202-302-010m13.8-24-5+1514 KICK SEAL(SPL.GRADE O.E TYPE) MATERIAL WITH PUCH ROD RUBBER 100 10 PCS 1503 91205-350-000 6-25-6 CLUTCH 200 20 PCS 1504 91202-GK4-722 18.9-30-5 MAGNET
200

Incoming search terms:

YAMAHA FZS 600 SERVICE MANUAL

0

Filed Under (Yamaha) by admin on 26-11-2010

download
CHECKING THE CONNECTIONS Check the leads, couplers, and connectors for stains, rust, moisture, etc. 1. Disconnect: lead coupler connector 2. Check: lead coupler connector Moisture Dry with an air blower. Rust/stains Connect and disconnect several times. 3. Check: all connections Loose connection Connect properly. If the pin 2 on the terminal is flattened, bend in up. 4. Connect: lead coupler connector Make sure that all connections are tight. 5. Check: continuity (with a pocket tester) Pocket tester 90590-03112 If there is no continuity, clean the termi- nals. When checking the wire harness, perform steps 1 to 3. As a quick remedy, use a contact revitaliz- er available at most part stores.
1-5 GEN INFO SPECIAL TOOLS 1 2 1 2 1 2 1 EB104000 SPECIAL TOOLS The following special tools are necessary for complete and accurate tune-up and assembly. Use only the appropriate special tools as this will help prevent damage caused by the use of inappropriate tools or improvised techniques. When placing an order, refer to the list provided below to avoid any mistakes. Tool No. Tool name/Usage Illustration 90890-01268 Ring nut wrench This tool is used to loosen and tighten the steering ringnut. 90890-01304 Piston pin puller This tool is used to remove the piston pin. 90890-01460 -01326 Damper rod holder T-handle These tool ar used for holding the damper rod when removing or installing the damper rod. 90890-01312 Fuel level gauge This gauge is used to measure the fuel level in the float chamber. 90890-01325 -01352 Radiator cap tester Adaptor These tools are used for checking the cooling system. 90890-01362 -01382 Flywheel puller Crank shaft protector These tools are used for removing the rotor and starter clutch. 90890-01367 -01381 Fork seal driver weight Fork seal driver attachment (ΓΈ41 mm) These tools are used when installing the forkseal.

Incoming search terms: