Ducati Multistrada Rear Powerbar Installation Instructions

0

Filed Under (Ducati) by admin on 25-10-2010

download
STEP #1 – Remove the left panel exposing the battery. STEP #2 – Mount the Powerbarâ„¢ on one of the frame members. Almost any frame member will work, you can select the location you like best [C]. STEP #3 – Next remove the negative battery connection, followed by the positive battery connection. Stretch out the wiring harness. Grab the socket end of the harness and start routing the wiring along the frame members toward the back of the bike [A]. Again almost any routing will work, the harness is designed to fit all locations with out any excess slack. Connect the red wire as follows: RED WIRE = BATTERY POSITIVE Tuck the fuse holder into the cavity in front of the battery [B]. Ty-wrap to nearby wiring. Connect the black ground wire to the negative post. STEP #4 – Install the fuse in the fuse-holder. Use a voltmeter to check if the polarity is correct. STEP #5 – Apply the remaining ty-wrap to the frame member that runs to the steering head. Do NOT allow the harness to directly contact the motor or exhaust

1991-1998 DUCATI 750ss 900ss POWERLET Installation Instructions

0

Filed Under (Ducati) by admin on 25-10-2010

download
STEP #1 Remove tail fairing & seat. STEP #2 Route wires starting at the battery and finishing at the bracket. STEP #3 Attach the wires to the socket and test. STEP #4 Mount the bracket. STEP #5 Look over your work. STEP #6 Put everything you took off back on. Detailed Instruction: STEP #1 – Remove the tail fairing, & seat. See the Ducati service manual. STEP #2 – Stretch out the wiring harness. Locate a wiring harness behind the frame rail[B]. Grab the socket end of the harness and start routing the harness by looping the wires up through the gap between the frame members just behind the battery[B]. You should be following the wiring harness behind the frame rail. The wires will exit in the underside of the seat area, just like the existing harness[D]. Attach the ground (black) wire under the hinge mounting bolt[C]. Tie wrap the harness under the cross member[E]. Go back to the battery area and install the fuse in the fuse holder than, tuck the fuse holder under the rubber strap in front of the plus terminal of the battery[F]. Slip the red wire under the red battery boot[F]. Connect the red wire to the battery posts as follows: RED WIRE = BATTERY POSITIVE STEP #4 -Attach the wires to the socket. The center terminal is plus and the outer ring is negative (see dwg below). Apply either dielectric grease or Vaseline to the terminals. Use a voltmeter to check if the polarity is correct