DUCATI 999R NITRO POWERED R/ C MOTORBIKE INSTRUCTION MANUAL

0

Filed Under (Ducati) by admin on 11-11-2010

download
FUEL SELECTION 1. Choose a fuel from a reputable, brand name company that is approved for car/truck use. Do not use airplane or boat fuels in your car/truck. Choose methanol based model engine glow fuel that has a nitro content in the range 10%-30% and 5% to 18% caster/synthetic oil content for lubrication. Lower nitro percentages will generally result in a cooler engine running temperature and therefore last longer before needing a rebuild; cooler-running engines also generally produce less power. 20% nitro is the most widely used fuel. 2. Fuel color is for identification purpose only and is not important to performance or durability of your engine. 3. Be careful. If the tank overflows it might get on your radio gear or on your brakes and it may create an unsafe driving situation. Always keep your fuel bottle closed when not in use. 4. Do not dispose of fuel or empty fuel containers in a fire. It may possibly cause fire or explosion. ENGINE 1. For proper engine break-in procedure, please refer to the manual of your engine. 2. Never run your vehicle without the air filter .If the vehicle will be operated in an area with fine dust, use filter oil or caster oil instead of fuel. It is important that the foam is only moist to trap dirt and allow air passage. With the foam too wet, limited air can pass through; therefore, limiting engine performance. 3. The parts around engine could be dangerously hot after operation. Do not touch it without any protection! RADIO OPERATION 1. When turning radio on, first turn on the transmitter and extend the transmitter antenna. 2. Then, turn on the receiver. When turning off, first turn the receiver off, then the transmitter off. FIRST AID 1. If you drink nitro fuel by accident, immediately drink large quantities of water and try to induce vomiting. Consult with physician right after then. 2. If the nitro fuel gets into your eyes, rinse them well with water. Consult with physician right after then. 3. If the fuel gets onto your skin, wash it well with soap and water. WARNING 1. Improper operations may cause personal and/or property damage. Thunder Tiger and its distributor have no control over damage resulting from shipping, improper construction, or improper usage. 2. Thunder Tiger assumes and accepts no responsibility for personal and/or property damages resulting from the use of improper building materials, equipment and operations. By the act of assembling or operating this product, the user accepts all resulting liability. If the buyer is not prepared to accept this liability, then he/she should return this kit in new, unassembled, and unused condition to the place of purchase.

YAMAHA XS650 Garage Carburetor Guide Introduction

0

Filed Under (Yamaha) by admin on 31-10-2010

download
Loop the hose around the bottom of the yardstick and secure it with wire or twist ties so that it runs straight up both sides; avoid pinching. Trim the ends to the same length, and cut an 8″ piece from each end. Suck ATF into the line so that it fills the tubing about 8″ high on each side. Splice the end pieces back on with the pilot jets. Remote Fuel Bottle. On OEM carbs with a central synchronizing screw,adjustment (see Section II.) is easiest with the tank removed. Make a remote tank from a 1 qt. plastic bottle. Install a 1/4″ hose barb in the bottom of the bottle and a lawn mower fuel valve in the line (an in-line filter is also a good idea). Attach a wire to the top of the bottle and hang it where you need it. Safety note: many plastics will break down with exposure to fuel. Be sure your material is fuel resistant, and empty the container immediately after use. This item is not strictly necessary. 5twins recommends rough adjustment with the tank removed, using fuel remaining in the float bowls, followed by fine adjustment with the tank in place, reaching in with a long screwdriver. You can also set the tank on a work bench or other elevated surface and run extensions to the carburetor lines. Compressor If you intend to do much mechanical work at all, an air compressor with sufficient capacity to power an impact wrench will pay for itself quickly. For carb cleaning, attach an air gun with a rubber tip.

Incoming search terms: