Honda GL 1800 FOG LAMP INSTALLATION INSTRUCTIONS

0

Filed Under (Honda) by admin on 24-11-2011

download
Disconnect the negative cable from the battery before installing this accessory. • To prevent scalding, allow the engine and cooling system to cool before installing this accessory. • The memories of the tripmeter, clock, radio andbsuspension system will be erased when you disconnect the battery. Reset the memories after reconnecting the battery. • Tighten the screws, bolts and nuts securely. • Trim the excess ends off the wire ties after attaching them to the wire harnesses. Do not allow the cut part of the wire tie to interfere with another harness or brake pipe. Using cutting pliers, cut out the marked areas from the front lower cowl. Finish the edges of the holes smooth and flat with a file. 1. Disconnect the negative cable from the battery. 2. Remove the front lower cowl and bolts as described in the Service Manual.

2002 GL 1800 Reverse Cable Inspection/ Adjustment PROCEDURE

0

Filed Under (Honda) by admin on 29-01-2011

download
INSPECTION/ADJUSTMENT PROCEDURE 1. Remove the right engine side cover (see S/M Page 2-4). 2. Check the cable clearance on the N (neutral) and R (reverse) cables. Note: It is not necessary to remove the center inner fairing or inspect the reverse shift actuator. . 6. Push the reverse shift switch to “OFF” and turn off the ignition. 7. Tighten the reverse cable lock nuts. 8. Reinstall the right engine side cover. PARTS INFORMATION No parts are required for this procedure. WARRANTY INFORMATION Normal warranty. After completion of the inspection/adjustment, submit one claim per VIN using the following information only: Template #: GL#5 Flat Rate Time = 0.3 hours The reverse cable lock nuts may not have been properly tightened on some GL1800 units. We have developed a procedure to inspect and adjust any affected units. Please follow the INSPECTION/ ADJUSTMENT procedures included in this Service Bulletin. AFFECTED UNITS 2002 GL1800 units with VIN range: 1HFSC470*2A102303 through 1HFSC470*2A102622 * indicates check digit Any unit in the above VIN range may be affected and should be inspected according to the procedures in this Service Bulletin. All units outside of the above VIN range do not require inspection.

Incoming search terms: