Honda GL1500 Gold Wing Motorcycles Trike Conversion Installation Guide

0

Filed Under (Honda) by admin on 19-12-2011

download
Secure and raise motorcycle 9 to 10 inches using a quality motorcycle lift. Remove the following from the vehicle. See OEM manual for detailed instructions. Items to be retained for reinstallation after modification are noted. • Left and right side-covers (to be re-installed with minor modification). • Seat (to be re-installed without modification). • Trunk. • Left and right passenger foot rests (to be re-installed without modification). • Left and right side-covers above passenger foot rests. • Battery and holder (to be re-installed without modification). • Left and right saddle bags (retain side cover mounting grommets for re-use). • Left and right mufflers. • Rear wheel. • Rear brake line to master cylinder.** • Reverse resistor assembly (to be relocated). • Swing Arm (Drive shaft boot will not be used). • Bank angle sensor. • Shocks. Air shock (non coil-over) to be reused. ** Thoroughly vacuum drain rear brake system, including feed line to left front caliper Modification to Trunk / Luggage Stay Removal from vehicle frame is not necessary. a. Cut the down tubes of the trunk stay and remove the lower section as shown in Figures 1 & 2 b. Trim rear upper tube-end rounded corners just outboard of welded nut. Trim line should be parallel with center line of vehicle. This will provide clearance for body when installed. Figure 2 (Inset) c. Remove the Hazard and Turn Signal relays from the center holder; bend Relay Holder Tab up 90°. Relays will be relocated to left and right sides. Figure 3

Honda GL1800 Gold Wing Motorcycles Accent Panel Installation Guide

0

Filed Under (Honda) by admin on 27-10-2010

download
1. Remove left engine side cover. 2. Unplug side stand sensor harness and remove side stand. 3. Cut plug from side stand wiring, leaving approximately 1 ½” of wire on plug. Connect green wires with supplied crimp to bridge side-stand sensor. Figure 1 4. Install modified plug to electrical harness of vehicle. Figure 1 5. Replace engine side cover. 6. Remove center inner fairing panel. 7. Remove lower setting bolts (not to be re-used) from front lower fairing. It is not necessary to completely remove this panel. 8. Lift the side mirror boots and disconnect the running / turn signal wiring. Figure 2 9. With the single plug end first, feed the supplied wire harness into the fairing just below the mirrors. Note: right side wire harness is blue, left is orange. 10. Continue working the supplied harness through the fairing until the single plug end is near the lower part of the lower fairing light nacelles. 11. Connect the supplied wire harness to the vehicles harness at the mirrors and replace mirror boots and center inner fairing panel. Figure 3 12. Remove the center stand and install the supplied cross brace using the OEM bolts and spacer. Install supplied 13 spacers / washers between bracket and OEM spacer as shown. Figure 4