HARLEY DAVIDSON SIGNATURE SERIES PILLION KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 14-04-2011

download
INSTALLATION 1. Install the grab strap (4) with the seat mounting studs (A) through the inner grab strap holes (F). 2. Refer to solo seat instruction sheet for installation of rider seat (C) and backrest (D). 3. Install the mounting nuts (E). 4. Tighten nuts snugly. 5. Slide slots on leading edge of passenger pillion (1) onto seat mounting studs (A) while sliding the pillion through the grab strap. 6. Install mounting screw (B) from stock seat through the mounting tab and tighten to 36-60 in-lbs (4-7 Nm) . After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) 7. Pull on seat and pillion to verify they are securely installed. SERVICE PARTS C E 1 B 2 D 4 A F is05690a Figure 1. Service Parts: Pillion Kit Table 1. Service Parts Table Part Number Description (Quantity) Item Not Sold Separately Pillion 1 51652-97A Mounting tab 2 3588 Mounting tab screw (2) (not shown) 3 51863-09 Grab strap 4 Items mentioned in text, but not included in kit: Mounting stud (2) A 2952A Stock screw B 51700-09 Signature Series Solo Seat Kit (purchased separately) includes Items C-E Seat C Backrest D 3638 Mounting nut (2) E Inner grab strap mounting holes

HARLEY DAVIDSON BADLANDER XL CUSTOM SEAT INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 03-02-2011

download
Removal of Stock Seat 1. Remove screw (8) to detach rear seat mounting bracket from fender. 2. Slide seat rearward to unhook front of seat from frame, then remove seat. 3. If equipped with a grab strap, remove hardware that holds it in place and remove strap. Installation of Kit Seat For 1996 and earlier models: Make certain you select the correct kit screw in step 1. Attempting to install a coarse threaded screw in a fine threaded hole, or vice versa, will damage threads. 1. Secure grab strap (2) to fender using washer (7) and appropriate screw (6) below: On 1995 and earlier models use 1/4-28 (fine) screw. On 1996 – 2003 models use 1/4-20 (coarse) screw. 2. Slide seat into position until front of seat engages frame, then secure bracket to fender with screw (8) using guide washer (3) between bracket and fender with the small washer diameter facing upwards. The guide washer will center the screw in the bracket hole and serve as a washer to protect the fender. NOTE For 1997 883 models, a retention nut and washer must be installed into the fender hole, covered with a plastic cap, where the rear seat bracket will be attached. A cable strap is included to aid in this installation. For 1997 – 2003 models: 1. Install grab strap (see step 1 for 1996 and earlier models). 2. Remove plastic cap from hole in fender where the rear seat bracket will be attached. 3. Place retention nut (5) over cable strap (9) so wide end of nut rests on eye of cable strap. Thread cable strap up under fender and through fender hole. Pull up on cable strap to hold nut snug against underside of fender. 4. With rib on retention nut seated into notch in fender hole, slide retention washer (4) into place from the rear. This will lock the retention nut in place. 5. Slide seat into position untilang=en