Motorcycle Engine Guard Adjustable Light Housing

0

Filed Under (Kawasaki) by admin on 05-11-2010

download
ADJUSTABLE HOUSING This highly polished, adjustable aluminum housing provides a very attractive means of adding the safety of Cuda TriOptic LED lighting to the engine guards on your Police Motorcycle. This newly developed 2.5 X 5.5 inch housing comes mounted on a ball swivel and can be adjusted and tightened to point LED lighting in any desired direction. This compact housing fits conveniently into position on the engine guard and is available with an engine guard clamp in a 1.00 inch or 1.25 inch diameter, which fits the engine guards of most popular motorcycles. The entire assembly is constructed of a highly polished aluminum alloy which blends very nicely with the chrome trim and accessories that are common on most motorcycles. COMPACT , LOW PROFILE CUDA LIGHT Our Engine Guard housing contains a newly developed model of the popular Cuda TriOptic light series with six LEDs positioned in a low profile format. This light housing provides a more compact but equally penetrating light source as the larger Cuda models. BUILT IN FLASHER As is Standard with all Cuda TriOptic products, this model can be programmed, prior to installation, to flash any one of eight selectable flash patterns; making the need for an external flasher unnecessary. EFFECTIVE LIGHT OUTPUT Cuda TriOptic lighting incorporates third generation, high intensity LEDs for dramatically bright light output. This high output light power is further enhanced by specially shaped lenses to ensure superior on and off-axis light distribution for maximum visibility. LOW AMP DRAW In addition to being extremely bright, the LEDs significantly reduce power consumption – a critical concern for fully equipped motorcycles. The 351011 (2-up) model, that is contained in this light housing, draws 0.7 amps per unit. RELIABILITY Cuda TriOptic LEDs are rated for over 100,000 hours of useful life – compared to 2500-5000 hours for a typical halogen bulb. Plus, Federal Signal LED products come with a 5- year warranty, and meet SAE and CAC standards for radio frequency interference. See the back of this page for technical specifications and ordering information so you can start specifying Cuda TriOptic LEDs for your motorcycles today!

2008-2009 KAWASAKI TERYX HEADLAMPS HIDTERYX HID KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Kawasaki) by admin on 25-10-2010

download
a. Remove rubber boot from the back of the headlamp housing assembly. b. Push down on metal latch and pull away from lip to release halogen bulb. Pull out halogen bulb. c. Insert HID bulb, line up bulb to fit into the bulb holder, lower latch to lock bulb in place. d. Replace Rubber boot on the back headlamp assembly. (Make sure to pull wires through the center of the rubber boot first before you start to pull down boot on the back of the headlamp assembly.) e. Make sure that the wiring, coming from the HID bulb, clears the black plastic housing that encases the headlamp assembly so connection from the bulb to the ballast is possible. If installed correctly there is no need for drilling or modifications of any type. 2. Ballast a. Mount ballast in location of your choice – recommended near the headlight. 3. Wiring Note: DO NOT modify the wiring that runs from the HID bulb to the ballast. It will cause the system to work improperly. It will void the warranty . a. Once ballast is installed connect corresponding wires from HID bulb to corresponding male / female plugs on ballast. b. To connect wiring from ballast to Teryx primary system i. Find wire extension with white triangular head with black, yellow & green wires at opposite end ii. Connect black off extension to black wire coming off ballast iii. Connect Yellow / Green wire to red wire coming off ballast iv. Connect triangular head to corresponding plug on Teryx Factory Wiring End