HARLEY DAVIDSON CHROME HANDLEBAR CLAMP BOLT KITS INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 02-02-2011

download
INSTALLATION Improperly aligned handlebars can contact the fuel tank when turned to the left or right. Contact with the fuel tank can cause cosmetic damage. (00372a) NOTES Check that the handlebar is centered on the risers. To make sure that the handlebar is centered, verify that the knurled areas on the outboard side of each riser are equal. Slowly turn the front wheel to the full right fork stop and then the full left fork stop to be sure the handlebar does not contact the fuel tank. If contact with the fuel tank occurs or the handlebars are not properly centered, see Figure 1. Slightly loosen the four upper clamp screws, and center the handlebar or raise the handlebar angle as necessary until proper clearance is obtained, then temporarily snug the screws, but do not fully tighten. 4 1 2 3 4 is00868 1. Upper clamp 2. Screw (4) 3. Handlebar 4. Handlebar risers (2) Figure 1. Handlebar Clamp Hardware 1. Remove and discard screws (2) that fasten upper clamps (1) to handlebar risers (4). Save washers under screw head for later use. 2. For Kit 94453-04: Select new chrome screws from the kit that match the length of the screws removed. For all other Kits: Select new chrome screws from the kit. 3. Slide washers previously removed onto screws, and thread screws through the upper clamps into risers. -J03586 1 of 2 4. If handlebar adjustments were made, snug screws but do not fully tighten. a. The bottom surfaces of upper clamps are offset, creating a gap between the clamp and riser on one side. b. Tighten clamps so the gaps appear to the rear of the handlebar, then tighten screw to 12-15 ft-lbs (16.3- 20.3 Nm). 5. If handlebar adjustments were not made, tighten screws to 12-15 ft-lbs (16.3-20.3 Nm). SERVICE PARTS

HARLEY DAVIDSON FXD HANDLEBAR RISERS INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 29-12-2010

download
Place a blanket folded several times over the fuel tank to help prevent any damage during the installation of the risers. Using a æ” socket loosen the two riser mounting bolts located on the bottom side of the upper steering head. Using a º” hex key wrench loosen the four handlebar top clamp bolts. 2. It will help having a second person to hold the handlebars while you change the risers. Remove the four bolts from the top clamp and then remove the clamp. Pull the handlebars up off the risers, pull them back and rest them on top of the blanket. 3. Remove the bolt from the bottom of one of the risers and remove the riser while keeping the bolt in place. Place one of the supplied Ω” washers onto the protruding bolt, and then the new riser (Note; There are LEFT & RIGHT risers.) and mount the bolt finger tight. (Take care not to scratch the top surface of the upper steering head while installing the new risers.) 4. Place the handlebars back up onto the new risers. Install the top clamp using the supplied four black 5/16-18 X 1 º” bolts. Set the height of the handlebars to the desired position; tighten the clamp bolts evenly making sure the gap between the clamps & risers are the same. (15-18 ft. lbs.) Tighten the two riser mounting bolts securely. (20-25 ft. lbs.). 5. Turn the handlebars all the way to the left and then right checking for any pulling or binding of the wires, hoses or cables. Also check that the throttle returns freely on its own