Honda CBR-929RR/ 954RR – Installation Instructions (slip on system)

0

Filed Under (Honda) by admin on 03-11-2011

download
Remove the lower fairing. Remove the rear turn signals. Remove the existing exhaust system from the HTEV valve rearward, save the mounting bolts for reuse. Save the stock exhaust can mounting bolt and nut for the end can to the passenger footpeg for reuse as well. Install the supplied HTEV joint plate to the rear of HTEV valve (see photo 1) using the stock mounting bolts. Tighten per factory specifications. Install the 2 Y-pipes to the joint plate, but do not install the supplied springs at this time. Install the S-Bend to the two Y-pipes, but do not install the supplied springs at this time. If you plan to keep the passenger footpegs, follow this step, otherwise, skip to step 8. Reassemble the right
passenger footpeg assembly in this order (from the subframe outwards): Spacer A, Stay Arm F, Spacer B, passenger footpeg assembly (from step 7 above). Use the supplied 8x110mm bolts D (2x) to fasten to the subframe (reuse nuts). See figure 3 for details. Proceed to step 8. If you plan to remove the passenger footpeg assemblies, follow this step and ignore step 6 above. Use: Spacer A and place the Stay Arm F against it. Use the supplied 8x50mm bolts E (2x) to fasten to the subframe (reuse nuts). See figure 3 for details, but use only the hardware specified in this step.
Slide the TiForce end can into place. Loosely attach the two rubber bands, stainless steel bands K, and stay / hanger G to the end can using the supplied 6mm hardware H. See figure 1 for details. Place the bands approximately 120mm from the edge of the end can. See figure 2 for details.