2002-2007 HONDA VFR 800 NSTALLING GALFER BRAKE LINE KIT

0

Filed Under (Honda) by admin on 08-12-2011

download
Remove the clutch fluid from the master cylinder on the left clip-on. Remove the fluid from the clutch line and slave cylinder. This factory line is NOT attached along the inner frame spar so here is a little trick that made this a 20- minute job including the bleed: 1. Remove the banjo bolts from the master cylinder and the clutch slave ends. 2. With a nice heavy wire tie, attach the slave end of the new braided line to the lever end of the factory line. Snip off the tail of the wire tie. Wrap this “joint” with electrical tape. 3. Pull from the factory slave end until you get the braided line end to the clutch slave. If it gets caught on something, try turning the end you are pulling
from.4. Remove the tape, carefully cut off the wire tie, install new sealing washers and bolts at both ends and torque to 17-21 foot/lbs. maximum. Bleed the clutch

2002 Honda VFR 800 VTEC Power Commander 111-210 Installation Instructions

0

Filed Under (Honda) by admin on 26-11-2011

download
If you feel that you are having any problems at all with the Power Commander II, disconnect it from your motorcycle. This will allow the motorcycle to run directly off of the stock ECU. The lights don’t come on when I turn the ignition switch on.
Check to make sure connectors are seated and the kill switch is in the “run” position. The on-board adjustment buttons do not hold their settings. Be sure to wait 20-30 seconds after making adjustments before starting or turning off the bike.
Can not upload to or download from the Power Commander II. Check to see that the serial cable is firmly in place. Verify that ignition switch is on and the kill switch is in the “run” position. My mouse uses the same serial port. If your computer has a PS/2 port purchase a DB9 to PS/2 adapter for your mouse. I get a “verify failed….” message when I upload a map to the Power Commander II. Programs running in the background or fluctuations in supply voltage (from outlet) can sometimes cause this error. In most cases, the information was sent properly to the Power Commander II. Pushing
the “upload all” button again should produce a “tables sent and verified” message. I typed in notes, but they didn’t save.
You need to first push the “accept” button in the notes window and then the “save file” button.

Incoming search terms: