SUZUKI VZR1800K6 And VZR1800/ ZK7 FUEL DELIVERY PIPE REPLACEMENT

0

Filed Under (Suzuki) by admin on 26-11-2010

download
NOTE: The fuel delivery pipe assembly can be removed from the throttle body without removing the throttle body assembly from the motorcycle. 1) Refer to section 6 of the service manual to remove the fuel tank and the air cleaner box. Place shop rags over the bore of each throttle body to prevent anything from falling into the engine through the throttle bodies. 2) Remove the wire harness clamp, disconnect the fuel injector couplers A and move the harness aside. 3) Remove the four fuel delivery pipe assembly mounting screws and remove the fuel delivery pipe assembly. 4) Replace the o-rings and seals with the new parts supplied in the kit (apply a small amount of engine oil to the o-rings and seals to ease the installation of the injector). To prevent damage to the o-rings or seals, don’t turn the injector when pushing it into the fuel delivery pipe and throttle body respectively. Install the new fuel delivery pipe assembly in the reverse order of removal. 5) Connect the fuel injector couplers A and clamp the injector harness to the fuel delivery pipe. DO NOT overtighten the harness clamp. 6) Connect the fuel tank, remove the shop rags from over the bore of each throttle body, and run the engine, checking for fuel leaks. DO NOT reuse the original fuel hose connector retainer. Confirm that the fuel hose connector has completely seated and locked (clicked) into position before turning on the ignition switch. 7) Refer to section 6 of the service manual to install the air cleaner box and the fuel tank. 8) Test ride the motorcycle to confirm proper operation. FUEL DELIVERY PIPE ASSEMBLY REPLACEMENT PROCEDURE

Air Shock Installation Instructions

0

Filed Under (Tips and Review) by admin on 24-11-2010

download
Air HoseInstallation. Choose the most convenient loca- tiononyour motorcycle for the air fill valve. Drilla 5/16″hole and install the air fill valve as shown in Figure 3orsecure air fill valve to frame tube. 2. Keep hose ends clean during installation because dirt can cause air leaks. 3. Install hose connector, tube clamp and two O-rings onto one end of the air hose (See Figures4&5) Apply rubber lubricant (soap solution, not oil) to the O-rings to ease installation on the air hose& into the shock absorber inlet. Plastic connector should just bottom on fitting. Do not overtighten! The function of the nut is to hold everything together in place, the O- rings do the sealing. Fin- gertightenonly (10 in/lb maximum). 4. After routing the air hose, trim the length to fit air fill valve. Install hose connector, tube clamp, and twoO-rings onto end of hose (See figures 4&5). Lubricate as above and assemble to air fill valve. Use the same procedure formating hose. Important —leaveasmall amount of slack in hose near shock absorber to allow for the slight move- mentofthe shock. Caution! Do not install hose near ex- haustsystem, battery or any other sharp edges or seat movement. Keep hoses clear of moving parts such as wheels or suspension components. Do not allow hoses to have excess slack and sag below the motorcycle. The hoses could catch on road surfaces or debris and could be damaged while the motorcycle is in motion. 5. If necessary the air hose can be secured along the motorcycle’swiringharness with tie-wraps. 6. Testing: Inflate system to 50 psi. Apply soapy water solution to all connections and check for air leaks. If there are any leaks, disconnect the suspected fitting and check for dirt or damage to the air line or the O-rings. Remove any dirt or foreign matter, re-lubricate the O-rings and reinstall. If unable to locate the leak, remove rubber boot from shocks and submerge pressurized components under water (in- cludingT-Valve) and check for leaks. If you cannot solve the air leak problem, please contact our technical staff for assistance